FULLINK M8507 Keyboard Case User Manual
- June 8, 2024
- FULLINK
Table of Contents
FULLINK M8507 Keyboard Case
Installation
Pairing Mode
Hold for seconds to enter pairing mode while blutooth LED flash, turn on
tablet and enable the bluetooth function,search for “FNEN Bluetooth
keyboard”,and click it to pair.
Auto Reconnect
when turn on again,the keyboard will automatically attempt to reconnect within
5 seconds, press any key to wake up the keyboa function.
Power Light Overview
Charging:
Fully Charged
Low battery:
Power Key
Press once to turn on the keyboard.Hold for3 seconds to turn off the keyboard.
Standby Mode
The keyboard will enter into standby mode after 1o minutes of inactivity.
Backlight
Press to cycle through the seven backlight colors.
Shortcut Keys
Troubleshooting Guide
If the keyboard stop working, please check the following:
- Ensure the keyboard is turned on.
- If the keyboard is out of battery,charge the keyboard.
- if the connection is unstable, turn off the keyboard and wait for 10 seconds before turning it back on.if the problem persists, disconnect the keyboard by going to the Setting-Bluetooth-Device list-“FNEN Bluetooth keyboard”,and “Select” or “Forget This Device”, then follow the Bluetooth pairing instructions to reconnect your keyboard.If the keyboard remains unresponsive, repeat the above steps.lf yoU are still experiencing problems, contact our
Customer service.
Reminder
- Built-in rechargeable battery can supply power for a few of weeks using.
- In order to prolong battery life, suggest turning off the keyboard when not using the keyboard for an extended period of time.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter.