aiwa ANCB7 True Wireless Earbuds User Guide
- June 8, 2024
- Aiwa
Table of Contents
aiwa ANCB7 True Wireless Earbuds
WIRED LISTENING MODE
IN THE BOX
Charging
POWER ON CONNECT
RESET
- Please make sure you forget “Aiwa ARC-2 ANC ” from your Bluetooth device settings before resetting
- Keep holding +/- buttons simultaneously for 10seconds until you see the red light flashing 3times. Headphone power OFF automatically
Noise Cancel
Please read this manual carefully before use.
Safety warnings
- Do not place any naked flame sources, such as lighted candles
- Dispose of batteries responsibly and be aware of the environmental effects of battery disposal Do not expose the batteries (batteries installed) to excessive heat, such as fire or the like
Warning
- To prevent possible hearing damage, do not listen at high volume levels for long periods. For your own safety, please be aware of your surroundings when using these headphones.
Control
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party.Responsible for compliance could void the user’s authority to operate this equipment.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirement. The
device can ben used inthe portable exposure condition with restiction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>