PHILIPS MS S-P Series Surface Mounted Pendants Instruction Manual

: June 8, 2024
: Philips

Table of Contents

MS S-P Series Surface Mounted Pendants
Disconnect before servicing
Documents / Resources

MS S-P Series Surface Mounted Pendants
Instruction Manual Surface mounted
TC MS Series

MS S-P Series Surface Mounted Pendants

Surface mounted

Dimensions in mm PHILIPS MS S-P Series Surface Mounted Pendants fig
2 ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING ELECTROSTATIC SENSITIVE DEVICES

– The luminaire shall be installed by a qualified electrician and wired in accordance with the latest IEE electrical regulations or the national requirements.
– This luminaire is not suitable for use as emergency lighting.
– The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
– Clean with dry cloth.
Inrush current

| PSU| | | DIA| | WIA
---|---|---|---|---|---|---
20W| 36W| 20W| 36W| 36W
| Electrical. characteristics
Imax (A)| 4.| 5.| | 18| 18| 5.
Tref (ps)| 66| 65| | 250| 250| 56
MCB| | | Luminaires max.|
2-10 A| 21| 21| | 21| 21| 15
B-16 A| 34| 34| | 34| 34| 24
C-10 A| 35| 35| | 35| 35| 25
C-16 A| 57| 57| | 57| 57| 40

For 27S and 32S, use PSU and DIA version 36W. PHILIPS MS S-P Series
Surface Mounted Pendants fig 3 PHILIPS MS S-P Series Surface Mounted Pendants fig
4

Disconnect before servicing

Luminaire has basic insulation between Low Voltage supply and control conductors.
The control gear and/or the external flexible cable contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualiﬁed person. The light source contained in this luminaire is not replaceable, in case of damage replace the luminaire.
Storage, installation, use, operation and maintenance of the products needs to be performed exactly according the instructions in this manual and/or other instructions as may be provided by us to guarantee safe use of the product over its entire lifetime. Failure to adhere to these instructions will invalidate your entitlement to warranty. Bolts with indication of torque strength on the drawing need to be tightened using a calibrated torque wrench. Pre-assembled bolts need to be retightened again to the required torque speciﬁcation to assure maximum strength over lifetime.
This product contains a light source of energy efﬁciency class: see table or label.

2022-02-10
4422 948 61329
© 2022 Signify Holding. All rights reserved
Data subject to change without notice
Keep for future reference: www.lighting.philips.com

© 2022 Signify Holding.
All rights reserved. This document contains information relating to the product portfolio of Signify which information may be subject to change. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.. All other trademarks are owned by Signify Holding or their respective owners.

Signify Holding.
The Netherlands

Documents / Resources

| PHILIPS MS S-P Series Surface Mounted Pendants [pdf] Instruction Manual
MS S-P Series, Surface Mounted Pendants, Mounted Pendants, Surface Pendants, Pendants, MS S-P Series Pendants
---|---