Winners Sun Plastic Electronic WS-19017-1 Cloud Shadow 3 Single AXIX Pan-Tilt Stabilizer User Guide
- June 6, 2024
- Winners Sun Plastic Electronic
Table of Contents
Winners Sun Plastic Electronic WS-19017-1 Cloud Shadow 3 Single AXIX Pan- Tilt Stabilizer
Bluetooth connection
Power on after long pressing the power button for 3 seconds, then turn on the phone bluetooth to enter search condition, and click “Dispho” in the searched equipment. The blue light will be on after the success of the connection.
Usage method
Remote control functions
- Power on or power off by long pressing “power key/front and rear camera switching” for three seconds; switch the front and rear camera by short press;
- Short press or long press the zoom keyto take a picture closer.
- Short press or long press the narrow key to take a picture further.
- Push the shot key to shot (photo mood)
- If you are unable to take photos/ switch camera/ adjust after connecting mobile phone Focus, press the combination switch key ( rst press the on key, then quickly press the zoom key, the blue light ashes twice, the switch is successful) and then try again.(Switch camera and adjust focus function only compatible with some mobile phones)
**Mount your phone onto the setfie stick
**
**
**
**Extend the monopod
**
**Usage mode of pan-tilt holder
**
After clamping the mobile phone and keeping the phone in natural balance, then long press the power button for 3 seconds to turn on the mobile phone.
After starting up, it will enter the stable mode, move the holder, and the mobile phone will always maintain a constant direction.
Clicking the power button of the pan-tilt holder, and it will rotate 90
degrees counter clockwise.
**Non- pan-tilt mode
**
When the pan-tilt is shut down or out of power, the rotation will screw tight to the locking direction, the rotation function of the pan-tilt disappears, and it will become an ordinary tripod selfie stick. (When the rotation is reset to the holder end, the pan-tilt mode will be restored.)
Use the tripod
Open the bottom tripod, uplift the pu II rod and put tripod on horizontal plane.
Charging
-
Holder charging mode
Connect the Micro USB interface of the pan-tilt holder for charging, and the red light will be on for a long time during the process of charging; the red lamp will be off automatically after charging is finished -
Charging Mode of Remote Controller
Connect the Micro USB interface charging, and the red light will be on for a long time during the process of charging; the redlamp will be off automatically after charging is finished.
Powering off
Remote controller: Long press photograph key for 3 s,blue lamp will flicker
for 3 times and then be off, which means machine is shut down.
Pan-tilt holder: Long press the “on” button for 3 seconds, and the green light
will be off, indicating it is power off.
Silicon rubber case for avoiding empty keys
When using the the mobile phone in horizontal screen status, please use this
accessory when the product cannot work normally due to touching the keys of
the mobile phone.
Tips
- When the equipment clamps the platform bracket, try to keep the equipment in the center, if not in the center, it is recommended to use the vertical screen mode.
- Selfie stick will enter sleep mode automatically if it is idled for 5 min after Bluetooth connection; press photograph key to recover connection.
- When using the Remote control, when the battery is low, the Remote control will have a flashing red light for reminder. Charge the selfie stick promptly.
- If the battery is running low, the indicator on the selfie stick will flash red. Charge the selfie stick promptly.
- For any imbalance of the Product after startup due to sharp change of temperature or humidity, please handle it as follows:Turn off the tripod head holder and dismantle it, and then place it on desktop horizontally as shown in diagram of and turn it on;after this, keep pressing the power key for 5 times, and the holder will give out 3 short beep sounds followed by 1 long beep sound;then it will turn off automatically and then start again; by now, the tripod head is recovered to normal status.
Warnings
- Watch your hands during use.
- The product is not designed for children under 14 years old.Do not swallow it.
- Do not dismantle or modify the product.
- Do not store the product in a humid environment.
- Keep the product away from heat sources.
- Do not expose the product to water or other liquids in case of damage.
FCC statements
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications or changes to this
equipment. Such modifications or changes could void the user’s authority to
operate the equipment.
The device has been evaluated to meet general RF exposure requirement, The
device can be used in portable exposure condition without restriction
Federal Communication Commission (FCC) Radiation Exposure Statement
Power is so low that no RF exposure calculation is needed.
Winners’ Sun Plastic & Electronics (Shenzhen)Co., Ltd. Production
Address: l/F-4/F of Factory 6 & 3/F of Factory 2, Detai Industrial Park,
496 Huarong Road,Langkou Community, Datang Sub-district, Longhua District,
Shenzhen
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>