GROWER S CHOICE TSL-800 LED Grow Light User Manual
- June 4, 2024
- GROWER S CHOICE
Table of Contents
GROWER S CHOICE TSL-800 LED Grow Light User Manual
Introductions
The TSL-800 is far more than a direct 1:1 replacement for traditional 1000w SE & DE HPS fixtures, it is an UPGRADE! We have thought ahead and future proofed this fixture, and also eliminated any need for diode lenses which will yellow and deteriorate the diodes more quickly. Utilizing our patented diode deployment allows us to achieve the desired angles of light distribution and an upgraded PAR output resulting in up to a 30% PAR increase using our new GC 3KF Bloom Phase spectrum. We have also further upgraded the Cooling capabilities by up to 40% with our new patented passive thermal management design. To make replacement of existing HID fixtures even more stress free, we will also be providing multiple mounting options for existing popular set-ups. Compatible with the Growers Choice Master Controller or CPS (Central Power Solution) this revolutionary new LED fixture can be operated by almost any level grower and is scalable for all cultivations, with the greatest yield potential in the industry.
- PPF calculations complied using our in-house integrating sphere measurements and typical spectroadiometric data for each LED to determine the fixture performance. Actual photometric results may vary within the LED’s manufacturer’s bin tolerance.
- Wattage values are typical expected values. TSL Horti Tech maintains and tolerance of +/- 10% range on flux and power consumption. Target light level can vary from projected levels depending on ambient temperature, room reflections values, and other conditions.
Safety Warnings
The TSL-800 is a passively cooled system with no moving components. Do not try to open or disassemble the fixture, it contains no service parts inside. Doing so may cause harm to the fixture and void warranty.
- Always adhere to the local rules and regulations when installing or using the fixture.
- Wearing protective gloves and glasses is recommended during installation.
- Always disconnect from power source before performing any maintenance to the fixture.
- The fixture will get hot during operation. Do not touch while the light is on. Keep this product away from children.
- Always allow at least 10 minutes for the fixture to cool down before handling.
- Do not touch the LED diodes.
- Keep the power cord away from hot surfaces.
- Do not plug this system into a supply voltage other than what is instructed on the fixture.
- Do not use the fixture when the power cord is damaged.
- Do not use the fixtures if the unit has been dropped, and there is damage to the enclosure or bars.
WARNING
Risk of electrical shock. To reduce the possibility of serious injury, always take the proper precautions and unplug the fixture before moving or cleaning.
CAUTION
To reduce the risk of overheating or fire, never place operating fixtures face
down on a flush surface. Always allow for adequate ventilation of fixtures and
power supplies.
CAUTION
LED and heat sink surfaces may be hot. Allow sufficient cooling time before
handling
CAUTION
To prevent eye damage, avoid looking directly at the unshielded LEDs.
CAUTION – RISK OF PERSONAL INJURY
Disconnect power before servicing or installing fixture. Lighted fixture may
be hot. To reduce risk of injury, turn off or disconnect power and allow to
cool before handling. Fixture must be grounded in accordance with appropriate
codes. Failure to do so may result in serious injury or death. Be sure all
power is off prior to installing fixture.
Installation:
Controllability:
The TSL-800 are fully controllable with a controller or through a Central Power System (CPS). If using a controller you will need RJ14 data cords.
Warranty:
TSL Horti Tech and Grower’s Choice warrants the mechanical and electronic components of their product to be free from defects in material and workmanship if used under normal operation conditions for a period of 1 year from the original date of purchase. If the product shows any defects within this period and that defect is not due to user error or improper use, TSL Horti Tech and Grower’s Choice shall, at its direction, either replace or repair the product using suitable new or reconditioned products or parts. TSL Horti Tech and Grower’s Choice warranty liability extends only to the replacement cost of the product. In case TSL Horti Tech and Grower’s Choice decides to replace the entire product, the limited warranty shall apply to the replacement product for the remaining initial warranty period.
TSL Horti Tech and Growers Choice shall not be held responsible for any damage caused by the operation of the unit, be it incidental or consequential or any type including, without limitation, damage or injury caused to other products or machinery or buildings. Nor will responsibility be accepted for loss of time or profit, or for any inconvenience caused in any way whatsoever.
[email protected]
www.growersc.com