FAGOR 3CFT-9060N Kitchen Extractor Hood Instruction Manual

FAGOR 3CFT-9060N Kitchen Extractor Hood

Dear customer,
From now on, your daily housework will be easier than ever before. Your appliance is exceptionally easy to use and extremely efficient. After reading these Operating Instructions, operating the appliance will be easy. Before being packaged and leaving the manufacturer, the appliance was thoroughly checked with regard to safety and functionality. Before using the appliance, please carefully read these Operating Instructions. By following these instructions carefully you will be able to avoid any problems in using the appliance. It is important to keep these Operating Instructions and store them in a safe place so that they can be consulted at any time.

Follow these instructions carefully in order to avoid possible accidents.

Dimension

NOTES ON SAFETY

• Before using the appliance, please carefully read this manual!
• The appliance is designed for household use only.
• The manufacturer reserves the right to introduce changes, which do not affect the operation of the appliance.
• The manufacturer shall not be liable for any damage or fire caused by the appliance resulting from failure to follow instructions in this manual.
• Cooker hood is designed to remove cooking odours. Do not use the cooker hood for other purposes.
• Connect the cooker hood operating in extraction mode to a suitable ventilation duct (do NOT connect the cooker to smoke or flue gas ducts, which are in use). It requires the installation of the air extraction duct to the outside. The length of the duct (usually a pipe of Ø 120 or 150 mm) should not be longer than 4-5 m. An air extraction duct is also required for telescopic and furniture hoods in ab-sorption mode.
• Cooker hood operating in air recirculation mode requires the installation of an activated charcoal filter. In this case, installing an extractor duct is not required, however, it is recommended to install an air guide vane (Mainly in chimney cooker hoods).
• The cooker hood features independent lighting and an exhaust fan that can be operated at one of several speeds.
• Depending on the type, the hood is designed to be permanently attached to a vertical wall over a gas or electric stove (chimney and universal hoods); on the ceiling over a gas or electric stove (island hoods); on the vertical built-in furniture over a gas or electric stove (telescopic and built-in hoods). Before installing, make sure that the wall/ceiling structure is strong enough to suspend the hood. Some hoods are very heavy.
• For details of the installation distance above an electric hob please refer to the product technical sheet If the installation instructions of the gas cooker specify a greater distance, this must be taken into account (Fig. 1).
• Do not leave an open flame under the hood. When the pots are removed from the burner, set the minimum flame. Always make sure that the flame does not extend outside the pot, because it causes unwanted loss of energy and a dangerous concentration of heat.
• When cooking on fat, supervise the pans constantly, because overheated fat can ignite.
• Unplug the appliance before any cleaning, replacing the filter or repair work.
• Cooker hood grease filter should be cleaned at least once a month because the filter saturated with fat is flammable.
• Ensure adequate ventilation (air flow) if other equipments such as liquid fuel stoves or heaters are operated in the room in addition the cooker hood. When the cooker hood is simultaneously operated with burning appliances re-quiring adequate fresh air from the room to work properly, their safe operation is possible if under pressure around these appliances is a maximum of 0.004 mbar (this does not apply when the cooker hood is used as an odour filter)
• Do not lean on the hood.
• The hood should be cleaned regularly both inside and out (AT LEAST ONCE A MONTH, following the indications concerning maintenance provided in this manual).. Failure to adhere to the rules concerning cleaning the hood and replacing filters results in a fire risk.
• If the power cord is damaged it should be replaced by a specialized service center.
• Ensure that it is possible to disconnect the appliance from the mains by removing the plug or switching off the bi-polar switch.
• This appliance is not intended for use by persons (including children) with physical, mental or sensory handicaps, or by persons inexperienced or unfamiliar with the ap-pliance, unless under supervision or in accordance with the instructions as communicated to them by persons responsible for their safety.
• Particular attention should be paid not to allow unaccompanied children to use the appliance.
• Make sure the voltage indicated on the nameplate corresponds to the local mains supply voltage.
• Before use, extend and straighten the power cord.
• Packaging materials (bags, polyethylene, polystyrene, etc.) should be kept away from children during unpack-ing.
• Before connecting the hood to the mains power supply always check that the power cord is properly installed and is not trapped by the appliance. Do not connect the appliance to the mains until assembly is complete.
• Do not operate your kitchen hood without the aluminum grease filters.
• It is strictly forbidden to cook dishes under on an open flame (flambé) under your kitchen hood.
• Always strictly adhere to regulations issued by the competent local authorities regarding the technical and safety requirements for fume extraction.
• Failing to tighten bolts and fasteners in accordance with these instructions may endanger life and health.
• Hanging kitchen hoods operate only in air circulation /odour absorber mode
• WARNING! Failure to install the screws or fixing the device in accordance with these instructions may result in electrical hazards.

UNPACKING

During transportation, protective packaging was used to protect the appliance against any damage. After unpacking, please dispose of all ‘elements of packaging in a way that will not cause damage to the environment. All materials used for packaging the appliance are environmentally friendly: they are 100% recyclable and are marked with the appropriate symbol. Important! Packaging materials (bags, polyethylene, polystyrene, etc.) should be kept away from children during uñpacking.

DISPOSAL OF OLD APPLIANCE

In accordance with, European Directive 2012/19/EU and local legislation regarding used electrical and electronic goods, this appliançe is marked with, the symbol of the crossed-out waste container. This marking indicates that the appliance must not be disposed of together with other household waste after it has been used.

The user is obliged to hand it over to waste collection center collecting used electrical and electronic goods. The collectors, including local collection points, shops, and local authority departments, provIde recyçling schemes. Propér handling of used electrical and electronic goods helps avoid environmental and health hazards resulting from the presence of dangerous components and the inappropriate storage and processing of such goods.

OPERATION

Cooker hood controls
Control Panel is shown in Figure 4, for reference it is also shown below :

The control panel is equipped with touch controls: Control functions are described below:

1. Touch the sensor to turn the appliance on or off. The fan will operate at the last selected speed.
2. Slider display indicates fan speed. Slide your finger on the slider to smoothly adjust the fan speed.
3. The L sensor turns the light on/off
4. The is the Off-Timer (see below for details).
5. Clean the filter indicator

Note: There are 9 fan speeds and highest speed is indicated by the entire length of the slider bar.

Off-Timer
Use Off-Timer to turn off the hood after a specified time. Use Off-Timer to filter the fumes out of the air after cooking. Delays of 5, 10 or 15 minutes are available. To activate the Off-Timer at any time, touch the Tensor once and the slider bars will flash. Then, adjust the slider length to select the delay:

Touch T to confirm the selected Off-Timer delay. Flashing T indicates that the Off-Timer has been enabled. Touch T again to cancel the Off-Timer.

Indication to clean the aluminum filters

When the indicator is on, you need to clean the aluminum filters. To acknowledge the indication, touch and hold T for approximately 2 seconds. Note: Clean the filter indication will be displayed after approximately 110 hours of fan operation.

Eco Boost
When operating at the highest speed, the appliance will eventually reduce the fan speed down to 6. The time until fan speed is reduced depends on the initial fan speed.

StandBy
The appliance will deactivate about 20 seconds after you turn off the fan and the light. Some sensors will be dimmed or turned off. Touch any sensor to activate the appliance.

Brightness adjustment
Use this function to adjust brightness. To adjust brightness, touch and hold the L sensor for about 2 seconds. The lighting brightness will change

Other important information concerning the operation of the hood
Operation in air circulation/odour filter mode. In this mode, the filtered air returns to the room through the outlets. Install the activated charcoal filter in this setting. It is recommended to install the air guide (available depending on the model, mainly in chimney cooker hoods). Air extraction operation: When the cooker hood operates in extraction mode, air is discharged outside through an extraction duct. Remove the activated charcoal filter in this setting. The cooker hood is connected to the air outlet opening using a rigid or flexible extraction duct with a diameter of 150 or 120 mm, and the appropriate clamps, which must be purchased at a hardware store. The appliance should be installed by a qualified installer. Fan speed: Lowest and medium fan speed is used in normal conditions and less intense odors, while the highest speed is used only when cooking odours are very intense, such as during frying or grilling.

Note (applies to universal hoods only): Due to the design of universal hoods you need to manually change the mode of operation. See Figure 8 for instructions on how to change the mode. Note (only applies to telescopic and in-built kitchen hoods): Furniture and telescopic cooker hoods operating in air recirculation mode require installation of the exhaust duct. The other end of the duct should be directed to the room as it will discharge filtered air .

Note: Hanging kitchen hoods operate only in air circulation/odour absorber mode

CLEANING AND MAINTENANCE

Maintenance
Regular maintenance and cleaning of the appliance will ensure the trouble-free operation of the cooker hood and extend its life. Especially make sure that the grease filter and activated charcoal filter are replaced according to the manufacturer’s recommendations.

• Do not use a soaked cloth, sponge, or water jet.
• Do not use solvents or alcohol, as they may tarnish lacquered surfaces.
• Do not use caustic substances, especially for cleaning stainless steel.
• Do not use a rough or abrasive cloth.
• It is recommended to use a damp cloth and a neutral detergent.

Note:
After several washes in the dishwasher, the colour of the aluminum filter may change. The change of colour does not indicate improprieties or the necessity to change it.

Grease filter
For normal hood operation, the grease filter should be cleaned every month in the dishwasher or by hand using a mild detergent or liquid soap.
Dismantling of the grease filter is shown on Figure 5.
The acrylic filter is used in some models. This filter should be replaced at least once every 2 months or more frequently if the appliance is used intensively.

Activated charcoal filter
Charcoal filter is used only when the cooker hood is not connected to the ventilation duct. An activated charcoal filter can absorb odours until saturated. The charcoal filter is not suitable for washing or regeneration and should be replaced at least once every 3-4 months or more frequently if the appliance is used intensively.

Dismantling of charcoal filter is shown on Figure 6.

Light
Use incandescent/halogen / LED modules of the same specification as those fac- tory-installed in the appliance. See Figure 7 for details how to replace lights. If there is no such figure in this manual, please contact the authorized service to replace the lighting module.

WARRANTY AND AFTER-SALES SERVICE

Warranty
Warranty service as stated on the warranty card. The manufacturer shall not be held able for any damage caused by improper use or the product.

Service

• The manufacturer reçommends that all repairs and adjustments be carried out by the Factory Service Technician or, the Manufactuřers Auțhorized Service Point. for safety reasons, repairs should be referred fO professIonals.
• Repairs carried Out by unqualified persons may seriously endanger the appli- ance user.
• The minimum warranty period for the appliance offered by the manufacturer, the importer, or authorized representative Is given in the warranty card.
• The warranty shall be, void it, you mąke āny iņdependent adaptations or alterations, tamper with seals or other appliançe safety devices or its parts or interfere
  with the appliance contrary to operating instructions.

In the event of appliance malfunction, request assistance or repair. If your appliance needs repair, please contact the sęrvice center. Please see the warranty card for addreşs and contact details of our service center. Before contacting us, please have ready the appliance serial number, whiçh can be found on the identification sticker: For your Convenience, please write it down below:

Manufacturer’s Declaration

The manufacturer hereby declares that this product meets the requirements of the following European directives:

• Low Voltage Directive 2014/35/EC
• Electromagnetic Compatibility (EMC) Directive 2014/30/EC
• ERP Directive 2009/125/EC
• Directive RoHS 2011/65/EC

and has thus been marked with the symbol and been issued with a declaration of compliance made available to market regulators.
https://www.fagorelectrodomestico.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>