BeeSmart BSHTH Magnetic Hive Tool Holder User Guide
- June 4, 2024
- BeeSmart
Table of Contents
BeeSmart BSHTH Magnetic Hive Tool Holder
OVERVIEW
INSTRUCTIONS
- Lace the Belt through the slots in the Magnetic Hive Tool Holder.
- Under the outer edge
- Over the center section
- Under the outer edge
- Lace the Belt through the open end of the Quick Release Buckle. Make sure Belt goes over Ribs on center bar. See diagram.
- To release buckle squeeze sides. You are now ready to put on.
- Install Magnetic Hive Tool Holder
- Put Belt around waist.
- Clip Buckle.
- Pull straps to adjust fit.
- Using Magnetic Hive Tool Holder
- Place hive tool on magnets.
- Preferred position is with short edge on top facing in.
- To remove hive tool grip in the middle and pull.
- To remove the Belt squeeze the sides of the Buckle.
Bee Smart Designs®
195 Atlantic Avenue • Garden City Park, New York 11040 800 600-7446 • Phone
516 741-3062 • Fax 516 742-3617
www.beesmartdesigns.com •
info@beesmartdesigns.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>