nearkey NKY-5277-D Bluetooth Smart Lock Access Control Instruction Manual
- June 9, 2024
- nearkey
Table of Contents
NKY-5277-D Bluetooth Smart Lock Access Control
Instruction Manual Reader Installation Instruction
NKY-5277-D Series
NKY-5277-D Bluetooth Smart Lock Access Control
Wiring Diagram
NKY-5277 series are mullion sized surface mount readers with exit button input
and both NO and NC relay outputs.
Exit button timing is fixed to 10sec.
| Operating Voltage | 12Vdc Only |
|---|---|
| Voltage Tolerance | ±10% |
| Current Draw | 12VDC/100mA |
| Operating Temperature | 10˚C~+45˚C |
| Humidity | 0~95% |
| Dimensions | 43mm (W) x 97mm (L) x 19mm (D) |
Installation Instructions
- Remove the back plate from the unit
- Drill 2 holes (A, C) on the wall for the screws and one hold for the cable (B)
- Knock the supplied plugs into the screw holes (A, C)
- Fix the back plate firmly on the wall with the 2 screws provided
- Thread the cable through the cable hole (B) and terminate
- Attach the unit to the back plate and screw the bottom lock screw in place (D)
Reset Nearkey Configuration
To reset your nearkey reader to factory default settings, unscrew the bottom lock screw and remove the unit from the back plate. On the rear of the unit at the bottom there is a reset push button. With the unit still powered up press and hold the reset button for 5secs then release.
Note
We recommend sealing the reader to the wall and the cable penetration from
behind to mitigate against any moisture ingress and insects. We also recommend
using the supplied varistors at both the lock and the reader relay output to
protect the onboard relay circuit.
Copyright ©2022
All Rights Reserved.
www.nearkey.co
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>