PRODVX GM-75 Universal Glass Mount Instruction Manual
- June 9, 2024
- Prodvx
Table of Contents
PRODVX GM-75 Universal Glass Mount
ProDVX GM-75 Glass Mount
Thank you for choosing the ProDVX GM-75 Glass Mount. This is a step-by-step
instruction manual to successfully install the ProDVX GM-75 Glass Mount for
your 10″ display. The ProDVX GM-75 Glass Mount contains the following parts:
- 1 x Glass Mount Cover Sticker
- 1 x ProDVX GM-75 Mount frame
- 2 x adhesive strips
- 4 x short VESA screws
- 2 x safety screws
Please contactsupport@prodvx.com if you need additional support.
Applying the Glass Mount Cover Sticker
- Clean the surface, preferably with Pro-Screen Cleaner spray.
- Affix the Glass Mount Cover Sticker to the glass where the tablet will be placed.
- Use a solid straight item to even out the Glass Mount Cover Sticker.
- Even out big bubbles with the straight item (little bubbles will disappear in time).
- Gently pull down the paper from the front side.
- Clean the Glass Mount Cover Sticker with Pro-Screen Cleaner spray and let it dry for three minutes.
Mounting your device
- Add the two adhesive strips horizontally to the backside of the ProDVX GM-75 Mount frame and remove the yellow paper from the two adhesive strips
- Firmly press the ProDVX GM-75 Mount frame onto the Glass Mount Cover Sticker and hold for ten seconds.
- Screw the four VESA screws into your 10″ display’s VESA holes. Tighten the screws by hand as they should stick out a few mm for affixing into the keyholes.
- Align the screws on the back of the tablet with the four large keyholes on the ProDVX GM-75 Mount frame and slide from left to right until you hear a click!
- Insert the two included safety screws into the top of the mounting plate. This will lock the mounting screws into place.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>