ProDVX APPC 22XP R23 Android Touch Display User Guide
- June 12, 2024
- Prodvx
Table of Contents
APPC 22XP R23 Android Touch Display
User Guide
Please check the website or scan the QR-code for more product
information.
www.prodvx.com/support
The information in this document is subject to change without notice. © 2023 ProDVX Europe B.V. All rights reserved.
This package contains
*Please note that it is preferred not to use power tools to attach the device to the mount or stand.
How to start:
Step 1: Take contents out of the box, make sure all components are present.
Step 2: Install wall/glass mount or desk stand, check designated
mount/stand manual for instructions.
Step 3: Connect to Internet through Wi-Fi or PoE+.
Step 4: If applicable, install and configure preferred application.
Quick connection settings
Step 1: Plug in PoE+ cable or power adapter to turn on display. If using PoE+ for both power and data, this was the final step. If connection to Wi-Fi is preferred, swipe up in the home menu to arrive in the app drawer. Once there, select Settings.
Step 2: In the settings menu, go to Network & internet, located at the top of the menu.
Step 3: In the Network & internet menu, select Wi-Fi.
Step 4: Turn on Wi-Fi and select desired Wi-Fi network to connect to
internet.
Note: If using ADB, please remember to turn off the ADB functionality
after use.
Please note that the Ethernet connection must be disabled in order to start
working over a Wi-Fi connection.
Caution:
Please note this product contains a battery. Please return the product to a
certified repair center for proper replacement of the battery; Disposal of a
battery can be dangerous.
WARNING:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area can cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Europe/UK – EU/UK Declaration of Conformity
This device complies with the essential requirements of the Radio Equipment
Directive (2014/53/EU). The following test methods have been applied in order
to prove presumption of conformity with the essential requirements of the
Radio Equipment Directive This equipment is compliant with Class A of EN55032.
In a residential environment this equipment may cause radio interference.
Correct Disposal of this product.
This marking indicates that this product should not be disposed with other
(household) waste. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please
use the return and collection systems or contact the reseller where the
product was purchased. They can take this product for environmental safe
recycling.
“FCC & CE RF Radiation Exposure Statement Caution: To maintain compliance with
the FCC & CE’s RF exposure guidelines, place the product at least 20cm from
near by persons.”
The suitable temperature for the ProDVX Display and accessories is 0°C-45°C.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>