National Hardware SN12171-00 Wall Gallery Hardware Kit Installation Guide

National Hardware SN12171-00 Wall Gallery Hardware Kit

Required tools

Parts in the box

For hook and nail hanger installation

1. Measure the picture frame
2. Measure from the top of the frame to the hardware on the back of the picture using a tape measure
3. Weigh your picture
4. Select the appropriate safe working load hanger from your box

Required tools

• Parts in the box

For wire and screw eye installation

1. Attach screw eyes about a quarter or third of the way down from the top of the picture

2. Measure the distance, mark it with a pencil, then repeat on the other side

3. Angle the screw eye upward at about a 45-degree angle. Don’t screw them by pointing directly toward one another

4. Measure and cut the wire: Find the middle of the frame and pull the picture wire up gently until you reach a point about 2 inches from the top

5. Measure the picture wire 5 inches through the eyelet and trim then repeat the same process of looping and knotting the picture wire to the screw eye
   that you did on the other side, leaving 5 inches of excess wire

6. Angle the screw eye upward at about 45 degree angle. Don’t screw them in pointing directly toward one another

• N12171-00
  

• Wall Gallery Hardware Kit
  

• N900-004
  

• 1-800-346-9445
  

• www.national-hardware.com

Documents / Resources

| National Hardware SN12171-00 Wall Gallery Hardware Kit [pdf] Installation Guide
SN12171-00 Wall Gallery Hardware Kit, SN12171-00, Wall Gallery Hardware Kit, Gallery Hardware Kit, Hardware Kit
---|---

References

• National Hardware

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>