trafficMaster H2038-803-1200 Sand Indoor 12 ft. Texture Beige Carpet User Manual
- June 9, 2024
- trafficMaster
Table of Contents
trafficMaster H2038-803-1200 Sand Indoor 12 ft. Texture Beige Carpet
SEAMING INSTRUCTIONS
STYLE NAME: Cay STYLE NO. H2038
DATE: 9/23/2016
REVISED DATE:
SIDE SEAMS
Photo A shows two light color yarns, Photo B shows the results of seaming two
light colors together, a light line.
Photo C shows two dark color yarns, Photo D shows the results of seaming two
dark colors together, a dark line.
Photo E shows the light color yarn keeping the two dark yarns separated. Photo
F shows a correct carpet seam.
This type carpet must be seamed from face side. Use a row finder to find and
separate a row, down the length of the seam. On one edge leave on the light
color yarn and on other edge leave on the dark color, then pull both edges
together and check seam for proper color alignment and proper seam fit.
If satisfied with seam appearance, apply seam sealer to both cut edges and
allow to dry.
Use a premium quality seam tape to seam pieces together, set thermostat on
iron at 3 to 3 1/2 and follow on seam with a round wheel seam roller, rolling
up and down seam. Now follow with a seam weight weighing no heavier than 10
lbs. Always move seaming iron in the carpets pile direction and allow seam to
completely cool before stretching.
CROSS SEAMS
Keep cross seams to a minimum. They are best when cut from back of carpet.
Using a straight edge [6 ft.], and carpenter square, adjust straight edge so
that the seam will be straight across width mark on each side either with a
notch cut into the edge or make a mark then snap a white chalk line from side
to side.
Now align the straight edge to the chalk line and cut carpet using a very
sharp razor knife; on piece of carpet with pile laying toward seam, hold razor
knife on a slight angle undercutting the face fibers slightly, other edge cut
straight up and down. Pull both pieces together and check seam for proper fit,
if satisfied with fit seam, seal both cut edges and allow to dry. Use a
premium quality seam tape to seam edges together, follow by rolling over seam
with a round wheel seam roller and a seam weight no heavier than 10 lbs. to
hold seam flat while cooling. Allow seam to cool completely before stretching.
RECCOMENDATIONS
Documents / Resources
|
trafficMaster H2038-803-1200 Sand Indoor 12 ft. Texture Beige
Carpet
[pdf] User Manual
H2038-803-1200 Sand Indoor 12 ft. Texture Beige Carpet, H2038-803-1200, Sand
Indoor 12 ft. Texture Beige Carpet, Texture Beige Carpet, Beige Carpet, Carpet
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>