Select Blinds Designer Double Cell Blackout Honeycomb Shades Instruction Manual

June 2, 2024
Select Blinds

Select Blinds Designer Double Cell Blackout Honeycomb Shades

Select-Blinds-Designer-Double-Cell-Blackout-Honeycomb-Shades-Instruction-
Manual-PRODUCT

HOW TO INSTALL

Inside/Ceiling or Outside Mount Cordless Lift Cellular or Pleated Shade Everything needed to install your shadeSelect-Blinds-Designer-Double-Cell-
Blackout-Honeycomb-Shades-Instruction-Manual-FIG-1

  1. Shade
  2.  Brackets/Screws
  3.  Cordless Lift Handle(s)
  4.  Optional Hold down Brackets
  5.  Optional Extension Brackets
  6.  Optional Side-Mount Brackets

Tools Needed

Inside/Ceiling Mount

  1. Place shade in the desired location and mark the front edge
  2. Measure 3″ in from the shade edge on both ends and mark
  3. Mark screw locations; center additional brackets, if applicable
  4. Position 5⁄16″ from the window casing for a flush mount
  5. Drill holes
  6. Screw brackets into place
  7. Mount shade into brackets
  8. Attach cordless lift handle(s)

For shades up to 24″ wide, clip a handle centered on the bottomrail; do not pinch fabric or slat. For larger shades, attach two handles, spaced evenly as far apart as you can comfortably reach. To lower shade, use handle(s) to pull down. To raise the shade, use the handle(s) to lift up.. Follow the same procedure for bottom-up/top-down.

Outside Mount

  1. Place shade in the desired location and mark cornersSelect-Blinds-Designer-Double-Cell-Blackout-Honeycomb-Shades-Instruction-Manual-FIG-11
  2. Measure 3″ in from the shade edge on both ends and mark
  3. Mark screw locations; center additional brackets, if applicable
  4. Drill holes
  5. Screw brackets into placeSelect-Blinds-Designer-Double-Cell-Blackout-Honeycomb-Shades-Instruction-Manual-FIG-13
  6. Mount shade into bracketsSelect-Blinds-Designer-Double-Cell-Blackout-Honeycomb-Shades-Instruction-Manual-FIG-14
  7. Attach cordless lift handle(s). (See another side for the diagram and instructions.)
  8. Optional Extension Bracket
  9. Optional hold-down bracketsSelect-Blinds-Designer-Double-Cell-Blackout-Honeycomb-Shades-Instruction-Manual-FIG-18

Optional Side Mount

Optional side mounts for shades 60″ or less: Assemble brackets.

  • Measurements from window casing to front of bracket for flush mount:
  • 13⁄8″ for 3⁄8″ Single Cell and
  • 1″ Pleated Shades
  • 15⁄8″ for 3⁄4″ Single Cell, 1⁄2″ Double
  • Cell and 2″ Pleated Shades
  • 23⁄8″ for 11⁄4″ Single Cell Shade

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Select Blinds User Manuals

Related Manuals