OKI Pro1050 Label Printer User Manual
- June 2, 2024
- OKI
Table of Contents
OKI Pro1050 Label Printer User Manual
IMPORTANT NOTICE
THE UNIT TO BE USED AS SLITTER ONLY, TAKE OUT THE WASTE REMOVER CORE.
⚠ Warnings
- The main plug of power supply cord set of AC/DC power supply is considered as disconnecting device of equipment.
- Do not operate the Matrix Remover while wearing loose fitting clothing or neck ties. Serious injury may result. If clothing or fingers are caught in the rollers, immediately disconnect the D.C. connector.
- Keep your hands away from the Matrix Remover at all times while the unit is running.
- When replacing Slitter blades work from the back blade housing to the front. This will minimize the chance of injury since you will not be working over already installed blades.
- When transporting the unit or any time the unit is not in use always lower the slitter station into the down/cut position. This will prevent accidental contact with the slitter blades. The two rollers below the slitter station act as a guard when the slitter station is in the down position.
- To prevent fire or shock hazard, do not expose the unit to rain or moisture. Operate the unit with only proper electrical specifications as labeled on the unit and the AC adapter.
WARNING
HAZARDOUS MOVING PARTS
KEEP FINGERS AND OTHER BOD PARTS AVVA Y
Note on Media Environment: 50% humidity and 72 degrees Fahrenheit is the optimal conditions for both storage and use of label stock. Store label stock in protective plastic wrappings. Rewrap partially used stock. Do not store stock directly on concrete floors. Label stock should be conditioned in this environment for 72 hours prior to use. Failure to store media in these conditions may result in media tension problems. Too much humidity will cause labels to curl on the edges.
RUN A JOB
⚠ WARNING: Before starting a new job, always make sure the waste matrix from
the previous job has been removed.
Do not attach the matrix from a different size label to an existing roll. This
will cause an uneven wrap which will cause the material to walk.
⚠ Note:
Make sure the media tension on all rolls is even. If this does not happen, the
entire waste process could be compromised!
SLITTER MODULE
The Slitter Module has 3 settings:
– Upper position (A), the blades are closed to allow the media loading;
– Middle Position (B) Used to align the blades with the center and/or edges of
the label. (Use thumb screw to lock the blade in place once it’s in position;
– Lower Position (C) Used to penetrate the media and start the slitting
process.
Screw or unscrew the thumb knob on the blade holder support to move slightly all blades to the right or to the left.
HOW TO ADD OR REMOVE BLADE HOLDERS
REPLACING THE SLITTER BLADES
Loosen the two screws holding the blade in place.
Replace the blade.
Secure the blades by tightening the screws back in place.
HOW TO ADJUST THE CLUTCH ON THE UNWINDER
With the clutch feature it is possible to control the the tension on the media during the process and adjust the tightness on the new reminded rolls.
PAPER PATH
Smart solutions for the labeling industry
Label rewinder, label unwinder, electronic label dispenser and more…
– FOR MORE INFO CONTACT YOUR RESELLER –
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>