VINNOVA 260065-BAT-WH Zamora Freestanding Bath Tub Instruction Manual
- June 3, 2024
- VINNOVA
Table of Contents
VINNOVA 260065-BAT-WH Zamora Freestanding Bath Tub
*** Image for installation purpose only
Please retain this manual after installation for future reference and maintance
Product must be installed in compliance with relevant Water Bylaws
IMPORTANT:
- Two people are required for installation
- Freestanding bath is not designed to take weight on the rim. Do not sit or stand on the bath rim
TOOLS REQUIRED FOR INSTALLATION
Spirit Level
|
Wrench
|
Tape
|
Marking Pencil
---|---|---|---
Sicilone Gun
Step 1
Adjust the bath feet until the bath base is 3mm above the floor; This can be done by turning the feet bars accordingly; Then use wrench to tighten the nuts on the bars
See figure 1
Feet set at 3mm above the floor
Step 2
Mark the floor with the outline of the bath, at the final installation position with the marking pencil
Step 3
Carefully tilt bath on its side and use flexible connector to connect waste outlet to the trap as illustrated on figure2
**Flexible connector installation
- .. Flexible connector and waste trap are not supplied**
Step 4
Position bath on the floor marking as marked on step 2, make sure that flexible connector is not kinked upward on installation as this will result in drainage issue
Step 5
Apply silicone around the base surrounding of the bath, see figure3
*** Do not use within 24 hours to let the silicone fully cure
Cleaning & Maintenance
A) To preserve the polished surface, after using your bath, clean with
soft cloth and warm soapy water to wash away any body oils or soap residue
that forms a ring tide mark
B) Do not use powders, pastes, creme cleaners, thinners, window cleaning
sprays or dry cleaning liquid, etc.
C) Stubborn marks or fine scratches may be polished out with Brasso
D) When coloured essentials oils are used, first test that the colour
won’t stain your bath. Always add oils into a bath full of water. Never pour
them into a empty bath
RECEIVINGYOUR BATH
A) Unpack and check for damage.
After receiving your bath, please unpack and remove all covering, checking
whether there is any damages. Repack the bath if it is not being immediately
installed. It will be rejected any claim for damage if not notified in a
timely manner.
B) Protect your bath.
Before commencing installation, ensure the bath is completely protected, leave
covering in place until the bathroom is complete, Scratches and cracks
incurred during installation are not covered by the warranty.
WATER TESTING
A) Water test your bath prior to enclosing to ensure it drains correctly
as no claims for non-draining baths will be valid after enclosing or tiling
has been done
B) Water test overflow pipe and waste to ensure they are not leaking
REPAIRS
Scratches and cigarette burns can be in proved with 1200 grade wet and dry sand paper then repolished with Brasso polishing compound. Always polish scratch in a circular movement
Customer Support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>