DOMETIC Power Awning Pro QSG Programming User Guide
- June 3, 2024
- Dometic
Table of Contents
Programming
Quick Start Guide
Power Awning Pro QSG Programming
THIS QUICK START GUIDE IS INTENDED AS A GUIDE ONLY AND IS NOT INTENDED TO PROVIDE ALL INFORMATION AND WARNINGS RELATED TO THE PRODUCT. REFER TO YOUR OPERATING AND INSTRUCTION MANUALS FOR ADDITIONAL IMPORTANT INFORMATION AND WARNINGS, INCLUDING ADDITIONAL SAFETY WARNINGS.
| Model | For Part Numbers |
|---|---|
| Power Awning Pro | 3316518.XXX, 3316519.XXX, 33117114.XXX, 3317115.XXX, |
3316554.XXX, 3316520.XXX
Complete each programming step within four seconds of the previous step to keep the receiver in pairing mode.
| Step | Operation | Audible Alert | Awning Movement |
|---|---|---|---|
| 1 | Turn Power On | ||
| Beep x1 | None | ||
| 2 | |||
| Press Left P2 Button x2 | |||
| Beep x2 | None | ||
| 3 | |||
| Press Up Button x1 | |||
| Beep x4 |
Awning Jogs
3¹|
Press Left P2 Button x1|
Beep x1|
Awning Jogs
4²|
Press Up Button x1|
Beep x1| None
5²| Press Down Button x1| None| None
6²|
Press Left P2 Button x1|
Beep x3|
Awning Jogs
7²|
Set Sensor Dial to “0”| None| None
8|
Press Left P2 Button x1|
Beep x1|
Awning Jogs
9|
Press Left P2 Button x1|
Beep x1| None
10|
Press Programming Button x1|
Beep x1/Beep x5|
Awning Jogs
11|
Set Sensor Dial to “5”| None| None
12|
Press Programming Button x1|
Beep x1|
Awning Retracts
13|
Set Sensor to Desired Level (adjusting sensitivity can be done without
reprogramming)| To clear memory:
Press P2
□ (STOP button)
P2
Programming must then be restarted at Step 1.
- When using on 9500 awning, press the ▼ DOWN button at step 3 instead of the ▲ UP button.
- Steps 4-7 are only applicable to the 9100 awning series.
Revision A Form No. 3317464.000 05/22
©2022 Dometic Corporation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>