SCARLETT SC-KS57P61 Kitchen Scale Instruction Manual
- June 3, 2024
- SCARLETT
Table of Contents
SCARLETT SC-KS57P61 Kitchen Scale
DESCRIPTION
- Body
- Digital liquid crystal display
- ON/TARE» button
- Batteries compartment
- Unit of measure switch
- Battery 3V CR2032
IMPORTANT SAFEGUARDS
- Please read all instruction manuals before use and save it for future references.
- For home use only. Do not use for industrial or commercial purposes.
- Oiling of inner mechanism is not needed.
- Do not shock the scale with sudden loading or striking.
- Do not overload the scale.
- Never try to repair this appliance by yourself. In case of failure, contact the nearest seller.
- If the product has been exposed to temperatures below 0˚C for some time it should be kept at room temperature for at least 2 hours before turning it on.
- The manufacturer reserves the right to introduce minor changes into the product design without prior notice, unless such changes influence significantly the product safety, performance, and functions.
- Manufacturing date is indicated on the unit and/or on packing as well as in accompanying documents in the following format XX.XXXX where first two figures XX is the month of production, and following four figures XXXX is the year of production.
OPERATING INSTRUCTIONS
START TO USE
- Scales are intended for weighing products and ingredients during cooking.
- Open the battery compartment on the back side of the scale. Remove the safety film. The scale is ready for operation.
- Place the scale onto a flat hard horizontal surface. Do not place the scale on soft surfaces.
- Press «ON/ТARE» button to turn on the scale.
- Wait for a few seconds for the display to show a «0».
- Place the product onto the scale; the scale will indicate the weight of the product.
- On the back side of the scale, there is a unit of measure switch. Use it to set the units of measure: grams (g) or kilograms (kg) ,pounds (lb) ounces (oz), milliliters water (ml water), milliliters milk (ml milk) To weigh the products successively without removing them from the scale, press the «ON/ТARE» button to set the scale to a zero before adding the next product.
AUTOMATIC SWITCHING OFF
-
If the display shows «0» or the same weight reading for 3 minutes, the scale will automatically turn off. OVERLOAD INDICATOR
-
When the scale is overloaded, the display shows «EEEE».
BATTERY REPLACING -
Replace the battery when the display shows «Lo».
MAINTENANCE AND CARE -
Wipe the scale with a soft cloth and cleaner, and then dry it.
-
Do not use any organic solvents, aggressive chemicals and abrasives.
STORAGE -
Complete all requirements of chapter MAINTENANCE AND CARE.
-
Do not put anything on scale when not in use.
-
Keep the scale in a dry cool place.
BATTERRIES USAGE RULES -
Battery contains harmful substances for human body. Keep the wrapping materials out of reach of children (choking hazard). The person, who swallowed a battery, should immediately consult a doctor.
-
Change the batteries regularly. Change all batteries at once using the elements of the same type.
-
It is forbidden to recharge or restore batteries in other manner, disassemble them, or throw into fire or hot-wire.
-
The battery must be inserted in the correct polarity.
-
Discharged battery can be a reason of scale breakdown. Remove the batteries compartment in case of long out-of-action time.
-
Do not throw the batteries into fire! Highly explosive!
-
Do not short-circuit the power clamps.
The symbol on the unit, packing materials and/or documentation means used electrical and electronic units should not be toss in the garbage with ordinary household garbage. These units should be pass to special receiving point.
The symbol on the unit, packing materials and/or documentation means the battery used in this product not be toss in the garbage with ordinary household garbage.
For additional information about actual system of the garbage collection, address to the local authority. Valid utilization will help to save valuable resources and avoid negative work on the public health and environment which happens with incorrect using garbage.