J T TSS001-N001-0 3×5 FT Storage Shed Installation Guide
- June 3, 2024
- J T
Table of Contents
J T TSS001-N001-0 3×5 FT Storage Shed
Thank you for choosing us!
Our goal is to provide high quality outdoor furniture with outstanding
customer service-all at an affordable price.
Please let us if you have any concerns.j
- Please wear gloves to avoid inj jury! TSS001-N001-0
- Send us an email at customerservice@lausaint.com, we will reply to you as soon as possible.
Please prepare below tools before installation. (Not Included)
ATTENTION:
- Please read this instruction carefully before installation and follow it strictly during installation.
- Ensure that there are no problems later due to installation errors.
- We have prepared extra screws for you to use in case of loss or damage.
Installation Notes
Please check the quantity of all parts before installation (Please refer to
the Parts Lists) and the appearance of the products. Please make sure the
product is correct before installation. If there is any problem, please
contact us directly.
Make sure the colored panels are facing outwards and all the holes match. The
panels are textured, please install the panels in the order specified in the
instructions. All lines and holes must be accurately matched to make the
storage shed more stable. Please ensure that all screws are tightened to
prevent the product from falling apart.
There is a protective film on the surface to protect the product, please tear
it off after installa-tion to get the final presentation. If you do not damage
the film during installation, it can also remain on the product to protect the
product.
Please place the product on a flat ground to prevent leaning and collapse. If
the ground is uneven, the door may can’t be closed.
Safety Precautions
We recommend two adults to complete the installation.Two adults installed
together will make the installation process easier and safer.
The gloves must be carried to prevent hand cuts during installation.
Take care when using power tools near water the use of a residual current
device (RCD) is advised. Please use the electric driver carefully during
screwing to prevent the screw from slipping and hurting your hand. (We
recommend that beginners use a manual screwdriver for installation.) Be
careful not to fall when installing the roof. Please steady the ladder and
make sure the product placed on a flat ground.
PLEASE KEEP THIS INSTRUCTION FOR FUTURE REFERENCE.
Component List
Top Plate
Shed Base Frame Assemble
Note: The larger hole is always covered over the small hole.
Shed Side Panels Assemble
Two Adults Are Required
Directly covering the excess parts of the left and right panels.
Directly covering the excess parts of the left and right panels.
Shed Top Frame Assemble
Shed Top Panels Assemble
Please steady the ladder make sure the product placed on a flat ground.
Door Assemble
View from the front, the vertical rod covers the horizontal rod. The larger hole is always covered over the small hole.
Please follow the steps ①-②-③-④ to install.
The final fixation should be done after all parts are aligned.
The exposed parts of the screw need to be covered with a plastic protective
cap. Crew position: Upper beam support rod K35-10L,K35-10R, K35-11R, K35-11L.
Front panel K35-7.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>