BOSCH GLM-BAT Battery Power Tool Instruction Manual
- June 2, 2024
- Bosch
Table of Contents
GLM-BAT Battery Power Tool
Instruction Manual
BA3.7V1.0AhA
GLM-BAT
IMPORTANT
Read Before Using
Safety Symbols
The definitions below describe the level of severity for each signal word.
Please read the manual and pay attention to these symbols.
| This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this symbol to
avoid possible injury or death.
---|---
DANGER| DANGER indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING| WARNING indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION| CAUTION indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
WARNING: Read all instructions. Failure to follow all instructions listed
below, may result in electric shock, fire and/or serious personal injury.
IMPORTANT SAFETY AND OPERATING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Charger Safety Rules
- SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for Bosch battery model BA3.7V1.0AhA. Do not substitute any other battery.
- Before using battery, read all instructions and warning markings on (1) battery pack, and (2) product using battery.
- Use only power adapter and USB C cable listed in the manual Specification section to charge the Bosch battery pack. Using other power adapter and USB C cable may increase the risk of fire, personal injury and property damage.
- Charge battery pack in temperatures above +32 degrees F (0 degrees C) and below +113 degrees F (45 degrees C). Only operate and store the battery at an ambient temperature between -4 °F (-20 °C) and 122 F° (+50 °C). This is important to prevent serious damage to the battery cells.
- Do not recharge battery in damp or wet environment. Do not expose battery pack to rain or snow. Water entering battery pack may result in electric shock or fire.
- Never submerge battery pack, tool or charger in fluid of any kind or allow fluid to enter them. Corrosive or conductive fluid (such as seawater or industrial chemical or bleach containing products, etc.) can cause short circuit which may result in fire, personal injury and property damage.
- Battery leakage may occur under extreme usage or temperature conditions. Avoid contact with skin and eyes. The battery liquid is caustic and could cause chemical burns to tissues. If liquid comes in contact with skin, wash quickly with soap and water. If the liquid contacts your eyes, flush them with water for a minimum of 10 minutes and seek medical attention.
- Place battery pack on flat nonflammable surfaces and away from flammable materials when recharging battery pack. Carpeting and other heat insulating surfaces block proper air circulation which may cause overheating of the battery pack. If smoke or melting of the charger or battery pack is observed, unplug the battery pack immediately and do not use the battery pack. Contact customer service immediately.
- Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. Damaged plug and cord may result in electric shock or fire.
- Disconnect the battery pack by pulling the plug rather than the cord. Do not recharge battery pack with damaged USB cord or plug; have them replaced immediately. Damaged plug or cord may result in electric shock or fire.
- Do not use battery pack if battery pack case is cracked. Using damaged battery pack may result in electric shock or fire.
- Do not disassemble battery pack or operate the battery pack if it has received a sharp blow, been dropped or otherwise damaged in anyway. Incorrect reassembly or damage may result in electric shock or fire.
- Before each use, check the USB cable and battery pack. Do not use if damage is detected. Never open the battery pack yourself, take it to a Bosch Factory Service Center, or qualified serviceman only using original replacement parts. Incorrect reassembly or using damaged product may result in electric shock or fire.
- Do not use attachments not recommended or sold by Bosch. Using attachments not recommended may result in electric shock or fire.
- Do not store battery pack in tool. Battery pack stored in tool over a long period of time could lead to battery pack damage and fire.
- Unplug battery pack from USB cable before storage, attempting any maintenance or cleaning. Such preventive safety measures reduce the risk of electric shock or fire.
- Keep the battery pack clean by wiping the charger housing with a damp cloth. Contamination may result in electric shock or fire.
- Replace battery pack if a substantial drop in operating time per charge is observed. Battery pack may be nearing the end of its life.
Battery Care
WARNING: When batteries are not in tool or charger, keep them away from
metal objects. For example, to protect terminals from shorting DO NOT place
batteries in a tool box or pocket with nails, screws, keys, etc. Fire or
injury may result.
DO NOT PUT BATTERIES INTO FIRE or expose to high heat. They may
explode.
Battery Disposal
WARNING: Do not attempt to disassemble the battery or remove any
component projecting from the battery terminals. Fire or injury may
result. Prior to disposal, protect exposed terminals with heavy insulating
tape to prevent shorting.
LITHIUM-ION BATTERIES
If equipped with a lithium-ion battery, the battery must be collected,
recycled or disposed of in anenviron mentally sound manner.
“The EPA certified RBRC Battery Recycling Seal on the lithium-ion (Li-ion)
battery indicates Robert Bosch Tool Corporation is voluntarily participating
in an industry program to collect and recycle these batteries at the end of
their useful life, when taken out of service in the United States or Canada.
The RBRC program provides a convenient alternative to placing used Li ion
batteries into the trash or the municipal waste stream, which may be illegal
in your area.
Please call 1-800-8-BATTERY for information on Li-ion battery recycling and
disposal bans/restrictions in your area, or return your batteries to a Bosch
Service Center for recycling. Robert Bosch Tool Corporation’s involvement in
this program is part of our commitment to preserving our environment and
conserving our natural resources.”
Important Charging Notes
- The battery pack was designed to fast charged only when the battery temperature is between 32˚F (0˚C) and 113˚F (45˚C). If the battery pack is too hot or too cold, the charger will not begin charging the battery. (This may happen if the battery pack is hot from heavy use). Once the battery temperature returns to its safe charging temperature, between 32°F (0°C) and 113°F (45°C), the charger will automatically begin charging.
- A substantial drop in operating time per charge may mean that the battery pack is nearing the end of its life and should be replaced.
- Remember to unplug charger during storage period.
- If battery does not charge properly: a. Check for voltage at outlet by plugging in some other electrical device. b. Check to see if outlet is connected to a light switch which turns power “off” when lights are turned off. c. If you still do not get proper charging, take or send tool, battery pack and charger to your local Bosch Service Center. See “Tools, Electric” in the Yellow Pages for names and addresses.
Note: Use of chargers or battery packs not sold by Bosch will void the warranty.
FCC Caution
The manufacturer is not responsible for radio interference caused by
unauthorized modifications to this equipment. Such modifications could void
the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE! This equipment has been tested and found to comply with the limits for a Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SAVE THESE INSTRUCTIONS
Symbols
Important: Some of the following symbols may be used on your tool.
Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to operate the tool better and safer.
| Symbol | Designation/Explanation |
|---|---|
| V | Volts (voltage) |
| Ah | Amp hour (measurement of battery capacity) |
| A | Amperes (current) |
| Direct current (type or a characteristic of current) | |
| This is the safety alert symbol. It is used to alert you to potential |
personal injury hazards. Obey all safety messages that follow this symbol to
avoid possible injury or death.
| Alerts user to read manual
| This symbol designates that this tool is verified by the Interlink Testing
Services.
| Designates Li-ion battery recycling program
Functional Description and Specifications
BA3.7V1.0AhA Li-ion Battery Pack
Li-ion battery pack
Type| BA3.7V1.0AhA
Article Number| 1 607 A35 0N9
USB port| Type C
Rated voltage| 3.7 V
Capacity| 1.0 Ah
Number of battery cells| 1
USB C cable
Article Number| 2610067499
Rated voltage| 5 V
Capacity| 1A max
Bosch power adapter (optional)
Input voltage| 120 Vac
Output voltage| 5.0 V
Output current| 500 mA
Recommended power adapter| 1 600 A01 43H
Alternate power adapter| Agency listed power adapter with output rated 5V,
minimum 1A.
This battery pack is only compatible with the following Bosch tools:
- GLM165-22
- GLM165-25G
- GLM165-27C
- GLM165-27CG
- GLM165-27CGL
Charging Instructions
WARNING: Use only power adapter and USB C cable listed in the manual
Specification section to charge the Bosch battery pack. Using other power
adapter and USB C cable may increase the risk of fire, personal injury and
property damage.
WARNING: Do not use the provided USB C cable in application higher than 5V
1A. Using USB cable beyond its rating may increase the risk of fire, personal
injury and property damage.
WARNING: Do not charge battery when USB C port is wet. Allow the USB C port
to dry out prior to charging battery. Moisture on USB port during charge may
cause fire, serious personal injury and/or property damage.
Note: The battery pack is supplied partially charged. To ensure full
capacity of the battery pack, completely charge the battery pack before using
for the first time.
Note: The battery pack can be charged in or out of tool. Tool can be used
while charging.
The lithium-ion battery pack can be charged at any time without reducing its
service life. Interrupting the charging procedure does not damage the battery
pack.
To charge the battery:
Insert USB plug in a USB compliant device. Lift the USB C cover. Insert the
USB C plug into USB C port. Once charging is complete, remove the USB C plug
and close the USB C cover to protect your battery.
Battery LED Indicator
The LED light is located under USB-C port cover. The battery LED indicator
shows the charging state of the battery pack.
| LED | Status |
|---|---|
| Off | Charger not connected |
| On | Full charge |
| Red | Charger input is wrong |
| Yellow | Charging |
WARNING: After charging battery, ensure the USB C cover is completely closed. Moisture entering battery may cause fire, serious personal injury and/or property damage.
Using Battery in Tool
WARNING: Use the Bosch rechargeable lithium ion battery packs only with
tools listed in the Specification section of this manual. Use of the battery
pack with other tools may increase the risk of fire, personal injury and
property damage.
WARNING: Remove the batteries from the tool when not using it for extended
periods. When storing for extended periods, the batteries can corrode and
self discharge.
The lithium-ion battery is protected against deep discharge by the Electronic
Cell Protection (ECP). A protective circuit switches the laser level off when
the battery is drained.
- Following the automatic shut off of the tool, do not continue to press the On/Off button. The battery can be damaged.
To insert the charged battery pack, slide it into the battery port until you
feel it lock into position. Do not use force.
To remove the battery pack, press the Li-ion battery pack locking mechanism
and pull the battery pack out of the battery port. Do not use force.
Limited Warranty of Bosch Portable and Bench top Power Tools
Robert Bosch Tool Corporation (“Seller”) warrants to the original purchaser
only, that all BOSCH portable and bench top power tools will be free from
defects in material or workmanship for a period of one year from date of
purchase. Seller’s sole obligation and your exclusive remedy under this
Limited Warranty and, to the extent permitted by law, any warranty or
condition implied by law, shall be the repair or replacement of parts, without
charge, which are defective in material or workmanship and which have not been
misused, carelessly handled, or misreported by persons other than Seller or
Authorized Service Station. To make a claim under this Limited Warranty, you
must return the complete portable or bench top power tool product,
transportation prepaid, to any BOSCH Factory Service Center or Authorized
Service Station. For Authorized BOSCH Power Tool Service Stations, please
refer to your phone directory.
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY ITEMS SUCH AS CIRCULAR SAW
BLADES, DRILL BITS, ROUTER BITS, JIGSAW BLADES, SANDING BELTS, GRINDING WHEELS
AND OTHER RELATED ITEMS.
ANY IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE YEAR FROM DATE OF
PURCHASE. SOME STATES IN THE U.S., SOME CANADIAN PRO VINES DO NOT ALLOW
LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATION MAY
NOT APPLY TO YOU.
IN NO EVENT SHALL SELLER BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES
(INCLUDING BUT NOT LIMITED TO LIABILITY FOR LOSS OF PROFITS) ARISING FROM THE
SALE OR USE OF THIS PRODUCT. SOME STATES IN THE U.S. AND SOME CANADIAN
PROVINCES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO
YOU.
THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE
OTHER RIGHTS WHICH VARY FROM STATE TO STATE IN THE U.S., PROVINCE TO PROVINCE
IN CANADA AND FROM COUNTRY TO COUNTRY.
THIS LIMITED WARRANTY APPLIES ONLY TO PORTABLE AND BENCH TOP ELECTRIC TOOLS
SOLD WITHIN THE UNITED STATES OF AMERICA, CANADA AND THE COMMONWEALTH OF
PUERTO RICO. FOR WARRANTY COVERAGE WITHIN OTHER COUNTRIES, CONTACT YOUR LOCAL
BOSCH DEALER OR IMPORTER.
Call Toll Free for Consumer Information and Service Locations
1-877-BOSCH99 (1-877-267-2499)
www.boschtools.com 2610067141
09/21
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>