TILTA F570 Side Power Handle Type II Battery Instructions

TILTA F570 Side Power Handle Type II Battery

POWER SUPPLY SIDE HANDLE

F570/F550 battery

SIDE RECORDING HANDLE

FOLLOW FOCUS SIDE HANDLE

F570/F550/E6N battery

INSTRUCTION

1. Power on/off
   To power on the handle, hold REC button for 3 secs till the LED light turns green To power off the handle, hold REC button for 3 secs till the LED light turned off

2. Record function
   Connect the handle to Nucleus Nano motor by the Micro USB cable
   . Connect Nucleus Nano motor to the camera by a correct recording cable.
   Click REC button once for recording, LED light will turn red
   Click REC button again for STBY, LED light will turn green.

3. Automatic calibration
   

   • Settings for infinite range lens
     Turn the lens manually to ,ts minimum value, attach Nucleus Nano motor to the gear ring tightly, then double click CAL button. When you see ‘CALING’ on the motor OLED screen, turn the handwheel to reach the maximum value of the lens, then double click CAL button. Wait for the motor to read the range status of the lens, setting finished
     

   • Settings for limited range lens
     Attach Nucleus Nano motor to the gear ring tightly, press and hold CAL button till you see ·CALING”on the motor OLED screen. Wait for the motor to read the range status of the lens. LED light will stay green during auto calibration.
     

   • AB stoppers function
     Attach Nucleus Nano motor to the lens gear ring tightly, press and hold CAL button till motor finishes reading the lens range. Turn the handwheel to A point click CAL button, LED light turns green, continue turning the handwheel to B point, click CAL button, LED light turns blue, setting finished

4. Follow focus handwheel calibration
   Press and hold REC button then double click CAL button until LED light turns blue, Turn the handwheel clockwise to the end, double click CAL button, LED light will be flash,ng in blue.Turn the handwheel ant, clockwise to the end, LED light will turn green, calibrat1on finished.
   You may need to calibrate the handwheel in the following circumstances:

5. Motor spins backwards when controlled by the side handle.

6. Motor cannot reach the minimum or maximum value of the lens after auto calibration is finished

7. DC/ MICRO USB power outputs
   Customized power cable is available. For example: can power BMPCC 4K for 3-4hrs

8. Low power alert function
   The LED light will be flashing in green when the battery is less than 20%.

9. Firmware upgrade
   You may download the firmware upgrade files from www.tilta.com Please feel free to contact our sales team for any inquires

ADAPTORS

The three adaptors below are compatible with power supply side handle. Please choose the correct adaptor.
Disclaimer:
This product is equipped with stable 8V and 12V power outputs. Please be cautions of the nominal voltage when using other equipment Damages that caused by abnormal operation will not be protected by warranty All rights reserved

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>