WATERSTONE 4055, 4055E, 4060, 4060E Soap/Lotion Dispenser Installation Guide
- June 3, 2024
- WATERSTONE
Table of Contents
SOAP/LOTION DISPENSER INSTALLATION
TRADITIONAL Models # 4055, 4055E, 4060, 4060E
BEFORE YOU BEGIN YOUR INSTALLATION:
4055, 4055E, 4060, 4060E Soap/Lotion Dispenser
|
---|---
Pull and remove spout (A) from dispenser body (B). Remove clamp nut (C) from
threaded shroud (D).| Fit dispenser body through 1-3/8” hole on counter or
sink. (No plumbers putty is required. O-ring seals base).
|
Thread the clamp nut. Tighten nut snug to underside of sink or counter.|
Thread bottle (E) into bottom of dispenser shroud.
|
Slide red tubing (F) into tube fitting (G) at bottom of spout.| From above the
counter, pour soap through dispenser body into plastic bottle. Do not
overfill.
|
Insert open end of red tubing down through dispenser and into plastic bottle.|
Push down on spout to secure over white O-rings
Pump spout a few times to get soap or lotion flowing.
41180 Raintree Court • Murrieta, CA 92562
1-888-304-0660 •
951-304-0520
www.waterstoneco.com
VEN-038-SOAP Rev. D
Documents / Resources
|
WATERSTONE 4055, 4055E, 4060, 4060E Soap/Lotion
Dispenser
[pdf] Installation Guide
4055 4055E 4060 4060E Soap Lotion Dispenser, 4055, 4055E, 4060, 4060E, 4055
Dispenser, 4055E Dispenser, 4060 Dispenser, 4060E Dispenser, Soap Dispenser,
Soap, Dispenser, Lotion Dispenser
---|---