PERFORMANCE PLUS BL-11975X Magnetic USB Charging Cable User Guide
- June 3, 2024
- PERFORMANCE PLUS
Table of Contents
PERFORMANCE PLUS BL-11975X Magnetic USB Charging
Congratulations on your ownership of the Performance Plus Rimming Wireless Remote Rechargeable Butt Plug. To keep your kit in top condition, please read through this user manual for cleaning and care instructions as well as charging instructions.
charging
The Performance Plus anal plug is rechargeable and comes with a magnetic USB charging cable. Charge anywhere USB compatible. It is highly recommended that you fully charge your plug for 2-2.5 hours before your first use. You will get up to 45 minutes of time on a full charge cycle. The charging time of the remote control is 2 hours. When charging, the product indicator light flashes. When fully charged, the indicator light remains lit.
remote control
Our anal plug comes with a wireless remote control. lo, activate, click the Button in the center of the remote. To activate the plug, press and hold the button on the base for 3 seconds. An indicator light will turn on for both the remote and the plug. Press the “+” button to start the rimming rotary motor Continue pressing the “+” and “-” to work through the 5 different speeds. Press “>” or “<” to cycle through the 5 vibration modes. Press the button on the remote to stop all functions. Press and hold the button on the plug for 3 seconds to turn it off.
play without the remote
Press and hold the button of the plug for 3 seconds until the indicator light turns on. The rimming rotary motor and vibration motor both work in the 1st gear. Press the button to cycle through all the functions. Press and hold the button on the plug for 3 seconds to turn it off.
care and cleaning
Wash your plug with warm water and soap before and after each use. Pat dry with a soft towel or allow the plug to air dry.
1-year warranty
- Register your product at www.blushnovelties.com.
- Valid only in US and Canada.
FCC Compliance Notice
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
- This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>