jane Micro Pro Newel Carbon Carrycot 2 Seat Koos Instructions
- June 3, 2024
- Jane
Table of Contents
jane Micro Pro Newel Carbon Carrycot 2 Seat Koos
PART LIST
- FOLDING STRAPS
- HOOD
- FOOT COVER
- PROFIX SYSTEM
- ANTI-ROCKING STRAP
- CARRY HANDLE
- RECLINING BACKREST
SAFETY WARNINGS AND INFORMATION
IMPORTANT: Read carefully and keep them for future reference.
WARNINGS:
- This product is only suitable for children who cannot yet sit up unaided.
- Do not leave the child unattended.
- Do not let other children play unattended near the carrycot.
- Do not use if any parts are missing, broken or torn. – Never use this carrycot on a stand.
- Do not add an extra mattress.
- Only use on a firm, horizontal, level, dry surface.
ADDITIONAL INFORMATION
- Only use original parts or parts that have been ap- proved by JANÉ.
- Do not place the carrycot near open flames or other sources of heat.
- Inspect the handle and the base of the carrycot re- gularly to check for signs of damage or wear and tear.
- Make sure that the handle is in the correct position before lifting or carrying the carrycot.
- This carrycot is designed for children from birth up to 9 kg in weight.
- Check that the child’s head in the carrycot is never lower than the body.
- This product is only suitable for children that cannot yet sit up unaided, turn over and who cannot push themselves up on their hands and knees.
- Do not add an extra mattress.
UNFOLDING
Place the MICRO-PRO2 folding carrycot on a flat surface 1 – 1a . Turn the
ProFix connector outwards. A Unfasten the folding straps so that the side
walls unfold completely. B Make sure that the walls are fully unfolded!
FOLDING
Fold the hood. Close the foot cover. 2 – 2a Pull the folding straps and fasten
them at the points found on the base of the carrycot. A Fold the ProFix
adaptor inwards. B
WARNING: This step must never be done with the baby insi-de the carrycot. It is inevitable that sharp points and areas where body parts could get trapped emerge during these operations.
RECLINING BACKREST
The back of the carrycot can be reclined so the baby can enjoy more of a
sitting up position. To raise it, pull the side strap upwards 3a . Once you
have pulled it as far as it will go, slowly release it until it locks into
place 3b . Check that it is firmly locked into place. To move it back to the
lying down position, pull the central strap 3c The mechanism will unlock and
you can gently release it back to the lying down position 3d .
USING THE HANDLE AND THE HOOD
This carrycot is fitted with a central handle for carrying. The handle is also used as a support for the hood. The handle can be rotated to fold the hood. To rotate it, press the two buttons on the sides. When you release the buttons, the hood will be locked into the nearest position. 4a . If you are using it as a carry handle, make sure that the handle is in the upright position and is properly locked in place. The hood can be folded, unfolded and removed. To fit the hood place both flaps around the handle and close the zips. The skirt is attached to the carrycot by another zip. For greater ventilation and to be able to see the child, the hood has an extra section made of mosquito netting: you can access this section by undoing the zip between the first and second sections of the hood. To remove the hood, follow the same steps in reverse.
WARNING: Do not place any weight on top of the hood.
FOOTMUFF
To settle your baby, undo the zip of the footmuff to the required level. 5a To fully remove the footmuff, undo the zip completely.
ATTACHING THE CARRYCOT TO A JANÉ PUSHCHAIR
To attach the carrycot to a Jané chassis, position the carrycot so that the
child’s head is facing away from the handlebar. Insert the Profix connectors
into the slots found in the armrests of the chassis, provided for this
purpose; you should hear the safe connection click. 6a CAUTION! Before use,
make sure that all the safety locks are fastened. To release the carrycot from
the chassis, pull the locking buttons found on the connectors upwards and lift
the carrycot off the pushchair by pulling it upwards. 6b To improve any
possible rocking, when fitting it onto your pushchair, you can use the
fastening system following the instructions. Adjust the strap to tighten it
.
- KENDO, KAWAI, CROSSLIGHT, NEWEL, MUUM Pro 7
- MUUM 8
- CROSSWALK 9
NOTE: Unlock the system before removing the carrycot.
MAINTENANCE
Clean the plastic parts with soap and warm water, then dry all the parts thoroughly. Hand wash and at a temperature not exceeding 30º C. Air dry, in a shady place. Prolonged exposure of the upholstery to sunlight may cause the fabric to fade. MICRO-PRO2 has a guarantee with all the precise specifications for its correct maintenance, it is important to keep these in good condition. For your safety as well as the correct maintenance of this product, it is important to have the product checked from time to time at any of our official workshops.
INFORMATION ABOUT THE GUARANTEE
- This item is guaranteed against manufacturing defects as stipulated in the legal Directives and/or regulations in force on guarantees for consumer goods applicable to the European Union and those of the country in which it is marketed.
- It is essential to present the purchase invoice or receipt in order to process the guarantee through the seller of the item or, failing that, through the manufacturer.
- The guarantee excludes anomalies or faults caused by misuse, non-compliance with the safety regulations and instructions for use and maintenance provided, or due to wear and tear caused by normal use and regular handling of the item.
- The label containing the serial number of your model must not be torn off under any circumstances as it contains information relevant to the guarantee.
JANE, S.A. – Pol. Industrial Riera de Caldes C/Mercaders, 34 – 08184 Palau Solità i Plegamans (BARCELONA) SPAIN
- Telf.+34 93 703 18 00
- email: info@groupjane.com
- www.janeworld.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>