TDX 740101 Infrared Heater Instruction Manual
- June 3, 2024
- TDX
Table of Contents
TDX 740101 Infrared Heater
IMPORTANT INSTALLATION AND WARRANTY INSTRUCTIONS
Thank you and congratulations on your purchase of the TXD infrared tube heater. Please read these instructions carefully before installing and using the product. Keep the instructions handy for future reference Electrical mounted must only be done by a licensed electrician and a “Certificate of Compliance must be issued at the completion of the installation.
LOCATION
The unit must be located and installed in accordance with AS/ NZS60335 and local building codes relating to damp situations. The unit can be installed in any room that requires direct radiant heating such as the Dining room, outdoor courtyard, balcony, living room, etc. The unit can be installed on the wall.
POWER
AC 240V/50Hz electrical supply is required. All electrical work must be carried out in accordance with AS/ NZS60335 or the latest edition thereof, and local building codes and regulations. Ensure that supply power is isolated before commencing installation.
Mounting
- Confirm the installation location: this product must be installed on a wall above 1.8 meters from the ground and must be kept away from flammable materials.
- Drill the mounting holes: remove the mounting bracket from the product. According to the hole position of the fixed bracket, mark the punching point with a marker pen. And drill with a φ8mm drill bit at the mark position, and the drilling depth is more than 35mm
- Fix the mounting bracket: the drilling position corresponds to the bracket hole position on the wall panel, then drive the expansion rubber plug into the wall, and use self-tapping screws ST5*40 to fix the mounting bracket on the wall.
- Fix the heater: m ake the pro duct connect the fixing b ra cket, adju st the appro pria te an gle, an d fix the h ea t er with screws and nuts. (The fixing screws can be installed in different holes, and the maximum adjustment angle is 30 degrees. The adjustable angle of the wing nut end slot is 10 degrees. Through the cooperation of the double holes and the wing nut end slot, the user can adjust the heater angle to meet the different heating requirements.)
- post-installation inspection: after the installation is completed, confirm that the product is fixed and tightened
- without loosening, and it works normally when powered on.
Circuit Diagram
REMOTE CONTROL
- Press one of these buttons to turn on and set the time duration.
- Put this button to turn off
MAIN TECHNICAL PARAMETERS
Model No.| Voltage
(V)
| Heat (W)| Hertz
(HZ)
| Dimensions（W
x D x H mm）
| Weight
(KG)
---|---|---|---|---|---
740101| 240| 1500| 50| 745x167x104| 2.5
CARE AND MAINTENANCE
Attention!
Careful and regular maintenance of your heater considering our instructions
assumes great importance to attain a long efficient operation of your
appliance.
- Check the filthiness of the Reflector and Heating pipe at least once a month. If necessary, apply cleaning and maintenance instructions.
- The number of checks may be increased considering the amount of dust in the environment.
- Check the deformation of the Reflector, Wire and Frame visually while cleaning the appliance. In case of deformation, consult your technical service.
- Check the Power Cord and Plug visually while cleaning the appliance. In case of deformation, consult your technical service.
Replacement Heat Tube
- Heat tube: the heat tube must only be replaced with 1500W (maximum) globes.
- Size : 486mm with lead line
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>