SOUND TOWN PAC180-6 Public Address Amplifier with Bluetooth User Manual

SOUND TOWN PAC180-6 Public Address Amplifier with Bluetooth

IMPORTANT SAFETY INSTRUCTIONS

1. Read all safety and operating instructions before using this product.
2. All safety and operating instructions should be kept for future reference.
3. Read and understand all warnings listed on the operating instructions.
4. Follow all operating instructions to operate this product.
5. This product should not be used near water, i.e. Bathtub, sink, swimming pool, web basement etc.
6. Only use dry cloth to clean this product.
7. Do not block any ventilation openings, it should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air.
8. Do not install this product near any heat sources, such as, radiators, heat registers, stove or other apparatus (including heat producing amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The side blade or the third prong are provided for your safety if the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord being walked on or pinched particularly at Plugs, convenience receptacles and the point where they exit from the apparatus. Do not break the ground pin of the power supply cord.
11. Only use attachments specified by the manufacturer.
12. Use only the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used use caution when moving cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation ports or any other openings.
15. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way; such as, power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped.
16. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
17. When the MAINS plug, or an appliance coupler is used as the disconnect device, the disconnect device should remain readily operable.
18. Protective Ground Terminal: The apparatus shall be connected to an AC main socket with a protective earth ground connection.

CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE CHASSIS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR

FEATURES

• 2 MIC (1 Priority MIC) and 3 LINE inputs
• 1 LINE output
• BLUETOOTH, USB, FM input with LCD display
• Level indicator, power and clip indicator
• Treble / Bass control & effect (Echo & Delay)
• Over current, short circuit protection
• 70V / 100V outputs
• Low impedance 4~16 ohm outputs
• 6 zone outputs (70V) with individual volume control

IN THE PACKAGE

• 1 PAC amplifier
• 1 Power cable
• 1 Remote control
• User Manual
• 1 Warranty Card

FRONT PANEL

1. MP3 PLAYER: Bluetooth, USB, FM and recorder (with LCD display)

2. MIC SOCKET: 2 x 1/4″ jack are provided for microphone inputs, MIC 2 is priority mic.

3. MIC LEVEL CONTROL: 2 rotated knobs to adjust the level of 2 microphone input signals.

4. LINE LEVEL CONTROL: 3 rotated knobs to adjust the level of 3 line input signals. (MP3 & LINE 3 share the same level control).

5. TREBLE: To increase or decrease the high frequency of the input signal.

6. BASS: To increase or decrease the low frequency of the input signal.

7. ECHO: To adjust the volume of echo effect.

8. DELAY: To adjust the delay depth.

9. 6 ZONE VOLUME: Individual volume control for 6 zone, each knobs adjustable in 5 steps.

10. INDICATOR: The ‘POWER’ LED illuminates when the amplifier is turned on; the ‘PROT’ LED flashes when fault is detected such as short-circuited or over heat, need to turn off the amplifier immediately; 3-segament LED indicates the master output level. The ‘CLIP’ LED lights up when the amplifier is nearing clipping, an occasional flickering is acceptable, if it’s lit continuously, adjust the level control and reduce the output volume. Failure to do so may lead to premature failure of your speaker.

11. CHIME: Push the button for a CHIME.

12. POWER SWITCH: To turn on/off the amplifier.
    REAR PANEL

13. LINE1, LINE2, LINE3 INPUT: 3 x RCA connectors are provided for 3 line level signal inputs.

14. LINE OUT: One RCA connector is provided for signal output (mixed output).

15. COM OUTPUT SOCKET: This is the common post, for whichever 70V/100V/4~16ohm connection, need to connect the negative ends to the ‘COM’ post.

16. LOW IMPEDANCE OUTPUT BINDING POST: For a 4~16 ohm low impedance speaker, connect the positive ends to the ‘4~16 ohm’ red post and the negative ends to the ‘COM’ post.

17. 70V OUTPUT BINDING POST: To provide 70V voltage output, for your speaker with 70V transformer, connect the positive ends to the ’70V’ red post and the negative ends to the ‘COM’ post.

18. 100V OUTPUT BINDING POST: To provide 100V voltage output, for your speaker with 100V transformer, connect the positive ends to the ‘100V’ red post and the negative ends to the ‘COM’ post.

19. 6 ZONE OUTPUT BINDING POST: To provide 70V voltage output dividing into 6 different zone.

20. Voltage selection: This switch is supplied for moving the amplifier from 110 voltage (U.S. Standard) to 230 voltage (European Standard). The switch needs to be set on proper voltage for your area.

21. AC INPUT: This receptacle is for connecting the included IEC power cable. It is important to supply the proper AC line voltage to the unit. Do not connect to intermittent or faulty power.

MP3 PLAYER WITH BLUETOOTH AND RECORDER

• A. MODE: Press to switch the signal source from BLUETOOTH/USB/FM
• B. PLAY/PAUSE.
• C. PREV: Short press to jump to previous song; press and hold to enter rewinding state.
• D. NEXT: Short press to jump to next song; press and hold to enter forwarding state.
• E. RECORD: Short press once to start recording, press again to end recording.
• F. MIC: Internal mic. for recording.
• G. IR: Infrared sensor for remote control.
• H. USB input socket.

SPECIFICATIONS

S/N

RATIO

| AUX| 88 dB| 88 dB
MIC| 116 dB| 116 dB
VOLTAGE| 110V/230V| 110V/230V
DIMENSION| 19″ x 15.3″ x 3.5″ (2U)| 19″ x 15.3″ x 3.5″ (2U)
PACKING SIZE| 21.9″ x 18.3″ x 7.5″| 21.9″ x 18.3″ x 7.5″
N.W.| 22 Lbs| 26 Lbs
G.W.| 24.5 Lbs| 28 Lbs

• How can we help you?
  

• CONTACT OUR US-BASED SUPPORT TEAM
  

• Simple or complex, your questions are important to us.

• For service, support, or more information, please contact the Sound Town support team:
  

• Email:support@soundtown.com

• 2021 SOUNDTOWN // Features and specifications are subject to change and or improvement without notice.

• Sound Town Inc. Los Angeles, California, USAwww.soundtown.com 

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>