Kensington Green Laser Presenter with Cursor Control Installation Guide

June 3, 2024
Kensington

Kensington LOGO Laser Presenter with Cursor Control
Installation Guide

INSTRUCTION GUIDE

Kensington Green Laser Presenter with Cursor Control -

Register Now!
register.kensington.com

Getting Started

| Kensington Green Laser Presenter
with Cursor Control - fIG1
---|---
Kensington Green Laser Presenter with Cursor Control -
fIG2| Kensington Green Laser Presenter
with Cursor Control - fIG3
Presentation Mode
Kensington Green Laser Presenter with Cursor Control -
fIG5| Mouse Mode

CAUTION! IMPORTANT SAFETY INSTRUCTIONS
The Presenter Expert™ Green Laser Presenter includes a built-in laser pointer. Therefore, aswith any laser pointer, it is important to adhere to the following warnings and safety instructions to prevent injury:

  • Never shine a laser pointer into a person’s eyes, or stare into the laser beam. Pointing a laser pointer into a person’s eyes, or staring directly at the laser beam, can cause instant temporary vision dysfunction such as flash blindness, disorientation or glare. This can be particularly dangerous if the exposed person is engaged in a vision-critical activity such as driving. In addition, prolonged and/or repeated exposure to the laser beam can be hazardous and damaging to eyes.
  • Never aim a laser pointer anywhere on any or person or animal. Laser pointers are designed to illustrate inanimate objects only. In some states and provinces, it is illegal to aim a laser pointer on a law enforcement officer or on any other person. The purchaser/user is responsible for insuring that his or her use of the laser pointer conforms to any local laws.
  • Do not point a laser pointer at mirror-like surfaces. A reflected beam can act like a direct beam on the eye.
  • Laser pointers are not toys. Do not allow a minor to use a pointer unsupervised. In some states and provinces, it is illegal for a minor to purchase and/or use a pointer. The purchaser/user is responsible for insuring that his or her purchase or use of the laser pointer conforms to any local laws.

Technical Support

Technical support is available to all registered users of Kensington products. There is no charge for technical support except the cost of the phone call, and long distance  harges where applicable. Technical Support Contact information can be found on the back page of this manual.
Technical Support Tips

  • You may find the answer to your problem in the Frequently Asked Questions (FAQ) section of the Support area on the Kensington Website:
    www.support.kensington.com.

  • Call from a phone where you have access to your device

  • Be prepared to provide the following information:
    – Name, address, and telephone number
    – The name of the Kensington product
    – Symptoms of the problem and what led to them

FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for  atisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

**CLASS 2 LASER SAFETY STATEMENT

**

This laser device complies with International Standard IEC/EN 60825-1: ED 2. 2007, Class 2 LaseProduct and also complies with 21 CFR 1040.10 and 1040.11, except for deviations pursuant tolaser Notice No. 50, dated June 24, 2007:

  1. Emission of a parallel beam of visible light;
  2. Maximum Power of 1 milliwatt CW, wavelength range 532±10 nanometers;
  3. Operating temp between 0 ° C (32° F) to 40° C (104° F).
    • Do not disassemble the device
    • Do not use the device outside of its specified operating temperature range. If the device is exposed to an environment outside of its prescribed operation, turn off the device and allow t temperature to stabilize within the specified operating range before using the device.

**CAUTION!
A set of warning labels in different languages is provided with this product. It is essential that the correct country-specific warning label is applied to the laser pointer for the  afety of the user and of the people nearby.
CAUTION!**
This device has no serviceable parts. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation  xposure.

FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to Part 15 of the FCC Rules. These limits are designed to  rovide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not  nstalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not   ccur in a particular installation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turning the equipment off and, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

MODIFICATIONS: Modifications not expressly approved by Kensington may void the user’s authority to operate the device  under FCC regulations and must not be  ade.  Operating Frequency Range: 2.402GHz to 2.478GHz Maximum RF Output Power: 0.0 dbm
FCC DECLARATION OF CONFORMITY COMPLIANCE STATEMENT
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This devicemay not cause harmful interference, and (2) This evice must accept any interference received, including interferencehat may cause undesired operation. As defined in Section 2.909 of the FCC Rules, the responsible party for his device is Kensington Computer Product Group, 333 Twin Dolphin Drive, Redwood Shores, CA 94065,USA.

INDUSTRY CANADA CONFORMITY
This Class B digital apparatus complies with Canadian ICES-003.
This device has been tested and found to comply with the limits specified in RSS-210. Operation is subject to the following two conditions: (1) This device may not cause  nterference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
CE DECLARATION OF CONFORMITY
Kensington declares that this product is in compliance with the essential requirements and other relevant provisions of applicable EC directives.
For Europe, a copy of the Declaration of Conformity for this product may be obtained by clicking on the Compliance Documentation link at www.support.kensington.com

THE FOLLOWING INFORMATION IS ONLY FOR EU-MEMBER STATES:
The use of the symbol indicates that this product may not be treated as household waste. By ensuring this product      is disposed of correctly, you will help prevent potential  egative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.  ensington and the ACCO name and design are registered trademarks of ACCO Brands. The Kensington Promise is a servicemark of ACCO Brands. Presenter Expert is a  rademark of ACCO Brands. All other trademarks are the property of their  respective owners.
© 2012 Kensington Computer Products Group, a division of ACCO Brands. Any unauthorized copying, duplicating, or other reproduction of the contents hereof is  rohibited without written consent from Kensington Computer Products Group. All  rights reserved. 09/12
Technical Support
Australia
1300 881 931
Nederland
010 713 1882

Kensington Computer Products Group
A Division of ACCO Brands
333 Twin Dolphin Drive, Sixth floor
Redwood Shores, CA 94065
Designed in California, U.S.A. by Kensington
Made in China
Patents Pending
www.kensington.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Kensington User Manuals

Related Manuals