ALPHA ANTENNA Remote Loop Kit Instruction Manual

June 3, 2024
ALPHA ANTENNA

Remote Loop Kit
Instruction Manual

Remote Loop Kit

Remote Alpha Loop Kit BETA Version Instruction Sheet 1.8
Description
The Remote Alpha Loop Kit enables Alpha Loop Antenna systems, which were purchased after January 1, 2017, to be retrofitted with a remote tuning option. Not for permanent outdoor use.

Technical Overview

The Remote Alpha Loop Kit uses a custom Mount (F) to install the Motor (C) on an Alpha Loop. This Motor (C) is wired to a Controller (D), which enables remote tuning  o occur. At the Mount (F), the Coupler (A) is used to  connect the Nylon Shaft of the Variable Air Capacitor in the grey Alpha Match box to the Motor Shaft (C). Once installed, the Power Supply (B) is attached to the Controller (D). A Cable (E) is then used to connect the Motor (C) to the Controller (D). This remote kit is built for indoor  se only and should not be installed outside.

Parts List

Please ensure that you have received the following parts.

ALPHA ANTENNA Remote Loop Kit - FIg

Support Contacts
If you have questions about your antenna, please feel free to email us at alphaantenna@gmail.com
Installation

  1. Make sure to turn the grey Alpha Match box over so that the nylon shaft is at the top.

  2. Loosen the two (2) screws that hold the black knob already on the box, and slide it off the white nylon shaft.

  3. Loosen the two (2) hex screws located on Coupler (A), which will face the grey Alpha Match box.

  4. a) While placing the Coupler (A) over the nylon (white) shaft of the capacitor, simultaneously place the notched Mount Hole (as depicted per 2b below) over the screw on the back of the grey Alpha Match box.
    4b) Secure the Mount (F.1) to the screw on the back of the Alpha Match using the Nut (F.2.).

  5. Then tighten all of the hex screws on Coupler (A).

  6. Ensure the +/– wires from the Power Supply (B) are connected to the +/– terminals on the Controller (D).

  7. Connect/secure the Cable (E) from the Motor (C) at the antenna to the Controller (D) +/- output terminals. jjj

ALPHA ANTENNA Remote Loop Kit - FIg1

Operation

– The knob on the Controller (D) turns the power on/off and controls the speed of the Motor (C).
– The toggle switch on the Controller (D) is switchable to tune the Alpha Loop frequency up or down.
– When the switch is on the Controller (D) in the center position the Motor (C) will stop.
– It takes about 90 seconds for the tuner to cycle through the entire tuning range.

Tuning
– The Controller (D) has a potentiometer that can be turned on and increase/decreased to control Motor (C) speed. The switch in the Controller (D) can be toggled to move  he Motor (D) left or right. The center position stops the Motor (C). There is a clutch assembly in the variable air capacitor that keeps  the gears from being stripped. Initial uning is best observed on your rigs S-Meter and then tweaked by  transmitting while adjusting for lowest SWR on your rigs internal. For easier tuning use an external SWR  eter or Antenna Analyzer.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals