Dopo lighting 916A-L0103K LED Outdoor Solar Bollard Light Instructions

: June 3, 2024
: Dopo lighting

Table of Contents

Dopo lighting 916A-L0103K LED Outdoor Solar Bollard Light
INSTRUCTIONS
Battery
IMPORTANT INFORMATION
SYMBOLOGY
SUPPLY CONNECTION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Dopo lighting 916A-L0103K LED Outdoor Solar Bollard Light

INSTRUCTIONS

Battery

The safety of this luminaire is guaranteed only if you comply with these instructions; remember to conserve in a safe place. The battery and solar panel for this luminaire are not replaceable by user The installation should be carried out by qualified personnel. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.

Suitable for indoor and outdoor use, taking the indicated IP rating into consideration. Keep away from direct contact to the ground and chemical substances. A pedestal at a higher level is required.

Do not use water high pressure cleaners.

IMPORTANT INFORMATION

Technical data: see fixture label

SAFETY INSTRUCTIONS

Electrical appliances must only be connected by competent persons.
Important! Before commencing installation work disconnect the mains cable from the power supply – remove fuse or turn switch to “OFF”! The power supply connection must be done with the suitable connecting box, as seen on illustrations.
This luminaire is only suitable for use in living areas (not for areas subject to moisture) and may be used only in accordance with its particular design. The maximum permissible ambient temperature is 25°C.
Do not attach luminaires to surfaces which are damp, freshly painted, or otherwise electrically conductive.
Connect the wires of the luminaire to the wires of the same colour that come from the wall or ceiling.
Use support systems that are in accordance to the weight of the luminaire.
Keep the wires and connections separated from any heat source.
To avoid damage to concealed wiring during installation, establish the direction of the supply cable before drilling fixing holes.
Keep these instructions in a safe place.
Use sleeves to cover the mains supply wiring to the fitting.
Cleaning is limited to the outer surfaces, shades or protective glass, reflectors and covers. Gold-finish and brass luminaires must be only be cleaned with a soft cloth (do not use cleaning agents of any kind). It is important to ensure that no moisture enters the terminal compartment or reaches any live parts!
As our products are subject to technical modifications, we cannot guarantee, that all information is always up to date. Please contact our technical department with any queries.
(Type Y) If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
Do not cover the luminaires with insulating material.
Do not use luminaries with frayed or cracked glass, until it is replaced
Not hang or supporting elements on the luminaires.
If the flexible cable or cord of this luminaire is damaged, it should be be replaced only by the manufacturer or its service or equivalent qualified or a person of equivalent qualification in order to avoid any risk.