Soft dB Deep Bluetooth Speaker User Manual
- June 3, 2024
- Soft dB
Table of Contents
Soft dB Deep Bluetooth Speaker
Instruction
Congratulations on getting your DEEP Bluetooth® speaker. read our simple instructions on how to use it.
WHAT’S IN THE BOX
- DEEP speaker unit
- 5V USB wall charger
- Micro USB charging cable
Power/Charge: Connect your speaker to a power source using the included Micro USB cable and wall charger.
Press the power button to turn the speaker ON/OFF.
AMBIENT SOUND MODE
(built-in sounds for better sleep & focus)
Press the left/right arrow buttons to play different built-in sounds.
10 ambient sounds included in the speaker.
Increase or decrease the volume by pressing the plus/minus buttons.
BLUETOOTH PAIRING MODE
Press the Bluetooth button to activate Bluetooth pairing mode.
The Bluetooth button light will blink. The speaker is ready to pair.
On your audio source device, connect to SoftdB // DEEP
Meaning of different button lights and blinking patterns.
Automatic Features
- Auto Blackout Mode: Button lights and sound masking back-lit indicator shut off automatically after 3 minutes.
- Settings Recall: Playback mode, sound selection, and volume level are remembered when the speaker is turned off and on again.
Resetting to factory settings
- Connect your speaker to a power source using the included Micro USB cable and wall charger.
- Press and hold the power button for over 4 seconds. The speaker will be restored to original factory settings.
Electrical Specifications
- Input voltage: 5V DC
- Input current: 1A
- Standby power: <1mW
Fcc
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment