Spralla 18951 3D Moon Lamp User Manual
- June 3, 2024
- Spralla
Table of Contents
Spralla 18951 3D Moon Lamp
PACKAGE INCLUDES
- Moon lamp
- Wood stand
- Remote control
- USB cord for charging
- User manu
SPECIFICATIONS
- Remote-controlled moon LED light with wooden stand
- Lights up in 16 different colours and with four different light modes
- Adjustable brightness
- 120lumen
- Lamp diameter: 15 cm
- Height (including stand): 20 cm
- Power:lW
- Input voltage: DC SV
- Battery capacity: 400mAh
- Battery time: 7-8 hours
- Charging time: 2-3 hours (USB cord for charging is included)
- The remote control uses a CR2025 button cell battery (included)
- Material: PVC and ABS (lamp), wood (stand)
Wooden frame assembly
Assemble the three L-shaped wood pieces into a stand, as shown in the picture
below. Place the lamp on the stand.
OPERATION INSTRUCTIONS
CHARGING
The charging port is located at the bottom of the lamp. Use the included
USB cable for charging. The lamp will glow with a faint red light while
charging, and the light will turn off when fully charged.
MANUAL ON/OFF AND CONTROL
Lightly press the charging port for 8 seconds to turn on the lamp.
Touch the charging port to toggle between different colours.
Long-press on the charging port to turn the brightness up and down.
Press the charging port for another 8 seconds to turn the lamp off.
REMOTE CONTROL
Use the remote control to adjust the brightness, and switch between colours
and different colour modes.
- Increase brightness
- Decrease brightness
- Power OFF
- Power ON
- Switch between solid colours
- Light mode with flashing lights
- Light mode with strobe effect
- Light mode with fading colours
- Light mode with smooth colour changes
TROUBLESHOOTING
Problem: The light does not turn on
Solution: Connect the lamp to a power source to activate it. Ensure the
light is fully charged before disconnecting it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>