NAKANISHI Sonic Cutter Zero Ultrasonic Cutter User Guide
- June 3, 2024
- NAKANISHI
Table of Contents
NAKANISHI Sonic Cutter Zero Ultrasonic Cutter
Operation Guide
See attached operation manual for details.
Power ON: Press [Main power switch]
- The LED on the control panel lights up.
Power level adjustment: Press [DOWN key] or [UP key]
- Displays the power level. (Can be adjusted during usage)
Startup: Press [ON / OFF key] or use the foot switch
- The ON / OFF key and the LED on the handpiece light up when starting up.
When using the optional foot switch
- Factory default setting: Pressing the foot switch to start and releasing it to stop.
- The setting can be changed to pressing the foot switch to start and pressing it again to stop. See attached operation manual to check how to change the setting.
If it is activated by a foot switch, it can only be stopped by a foot switch. See the other side for instructions on connecting.
Setup Guide
See attached operation manual for details.
Connecting the cords to back of controller
Loosen the set screw and insert the blade
- Remove the cap straight forward.
- Loosen the set screw by supplied hexagon wrench.
- Insert the no damaged blade completely into the horn.
Tighten the blade by set screw
Tighten the blade in center, in a position where both ends of the blade do not touch the horn. The standard tightening torque is 1.5 N/m.
For easy setup tighten the set screw lightly at first, then make adjustments
to the blade.
Make sure the blade has been installed correctly
The LED on the control panel lights up. If the WATT is smaller than 3.0 when
the maximum output power is displayed, the blade has been installed correctly.
3.0 W or less is only a guide line. It may be bigger or smaller depending on
the surrounding temperature and environment. Make sure of the installed
blade’s direction, whether the set screw is tight enough and whether the blade
is not damaged. If there is no improvement, replace the blade or set screw
.
700 Shimohinata, Kanuma,
Tochigi 322-8666, Japan
TEL: +81 289 64 3520
FAX: +81 289 62 1135
PR-K359E
Ver.1 2022-05-31 00.N
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>