FR ACARRO SWA930TS, SWA1730TS 9-17 Way Amplifier with Active and Passive TV Gain Instructions
- June 3, 2024
- FR ACARRO
Table of Contents
9-17 WAY AMPLIFIER WITH ACTIVE
AND PASSIVE TV GAIN.
SWA930TS
SWA1730TS
OPERATING INSTRUCTIONS
SAFETY WARNINGS
The product must only be installed by qualified persons, according to the
local safety standards and regulations. Fracarro Radioindustrie is free from
all civil and criminal responsibilities due to breaches of the current
legislation derived from the improper use of the product by the installer,
user or third parties.
The product must be used in full compliance with the instructions given in
this manual in order to protect the operator against all possible injuries and
the product from being damaged.
Installation warnings
- The product must not be exposed to any dripping or splashing and thus it should be installed indoors and in a dry location.
- Humidity and condensation could damage the product. In case of condensation, wait until the product is dry before using it.
- Handle the product carefully. Impacts can damage the product.
- Leave enough space around the product to ensure sufficient ventilation.
- Excessive temperatures and/or an overheating may affect the performance and the life of the product.
- Don’t install the product above or near any heat sources, in dusty places or where it might come into contact with corrosive substances..
- In the event that the unit is fixed to the wall, use the proper screw anchors suitable to the characteristics of the fixing support. The wall and the anchoring system must be able to support at least 4 times the weight of the unit.
Warning: to avoid injury, this appliance must be secured to the wall / floor depending on the installation instructions. The product must be connected to the grounding electrode of the antenna system in compliance with standard EN 60728-11. The screw provided for this purpose is marked with the symbol
It is recommended to comply with the provisions of the standard EN60728-11 and to connect this screw to the main earth node of the plant (do not connect to intermediate points).
Earth screw/Faston connector symbol
General warnings: In the event of a malfunctioning, do not try to fix the product as the guarantee would be invalidated. Although the information given in this manual has been prepared carefully and thoughtfully, Fracarro Radioindustrie S.r.l. reserves the right to modify it without notice and to improve and/or modify the product described in this manual. See the website www.fracarro.com to have information relevant to the technical support and product guarantee.
PRODUCT DESCRIPTION
The SWAXX30TS Serie belongs to the amplifier range with 9 inputs (8 satellite
polarities and TV) and 17 inputs (16 satellite polarities and TV); it was
designed to fulfil every installation requirement in small and medium
distribution systems.
The TV signal can be adjusted using the dip switch on the top right side of
the mechanical case. The amplifier have to be fed through the Jack connector
or through his trunk
lines, the choice is made moving the dip switch on the bottom left side; each
port has a LED which indicates the correct supply of the product. The serie is
composed by 2 products: 9 and 17 inputs with 30dB gain.
The product can be used with SWI..TS and SWP..TS multiswitches.
The product ensures high quality in a compact size, its inputs are
distinguished by different colours to make the cable connection faster and
easier.
PRODUCT INSTALLATION
Use plastic brackets for installing the switch as shown.
Earthing screw.
Connect the power supply to the DC port (bottom left side)
IMPORTANT: use only optional PSU (PSU1215TS or PSU1340TS), an incorrect
voltage (ex. 18V) will damage the product. The amplifier can also be fed by
trunk lines, the voltage has to be within 12V and 14V; if it is used an higher
voltage (ex. 18V) the amplifier will be damaged.
USER’S INSTRUCTIONS
when the product is correctly fed, the voltage is sent to all input satellite ports, allowing to feed the connected LNBs.
The TV signal can be adjusted using the dip switch on the top right side of the mechanic.
OPERATING LEVEL
| |
---|---|---
SWI908TS| 70 dBµV| 100 dBµV| 79 dBµV| 97 dBµV
SWI912TS| 70 dBµV| 100 dBµV| 79 dBµV| 97 dBµV
For 30 SAT channels
For 42 TV channels
LED Power ON: if the amplifier is correctly powered the LED will be ON. If
there is a short circuit in the satellite lines, the LED will be OFF; in this
case is recommended to disconnect the power supply, remove the short circuit
and restore the power supply, the LED will turn ON again.
CONFIGURATION EXAMPLES
TECHNICAL SPECIFICATIONS
| SWA930TS| SWA1730TS
---|---|---
Number of inputs| 8 SAT, 1 TV| 16 SAT, 1 TV
Number of outputs| 8 SAT, 1 TV| 16 SAT, 1 TV
| Bandwidth| 950-2300MHz
Gain| 30dB| 30dB
Uotilt| 7dB
Attenuation adjustment| 20dB| 20dB
Max Output level (1M31| 112dBpV
Return loss| 10dB
| Bandwidth| Active TV: 47-862MHz
Passive N. 5-862MHz
Active Gain| 18dB| 18dB
Passive Gain| -2dB| -2dB
Attenuation adjustment| 20dB| 20dB
Max Output level (IM3)| Active TV: 110dBpV
Return loss| 10dB
Isolation Output SAT-SAT| 30dB
Supply voltage| 12-14V
Consumption (@13V)| Active TV: 1150mA
Passive TV: 1000mA| Active TV: 2150mA
Passive TV: 2000mA
Power supply plug| 2.1x5mm 5x12mm
Internal positive, external negative
Max LNB supply| 2000mA
Dimensions| 170x
120×40| 290x
120×40
Operating temperature| -10 to 55 °C
The technical data are nominal values and refer to an operating temperature of 25° C.
| GB: Power supply I: Alimentatore | PSU1215TS | PSU1340TS |
|---|---|---|
| Output Voltage | 12V | 13V |
| Output Current | 1500mA | 4000mA |
| Main voltage | 120-240V, 50-60Hz | |
| Isolation | Class II | |
| Power supply plug | 2.1 x5.5x12mm |
Internal positive, external negative
Dimensions| 90x70x45mm| 110x52x34mm
Operating Temperature| 0 to 40 °C
Not included
The technical data are nominal values and refer to an operating temperature of 25° C.
CONFORMITY TO EUROPEAN LAWS
Fracarro declares that the product complies with EU Directive 2014/53 and 2011/65/UE. The full text of the EU Declaration of Conformity is available on the following website ce.fracarro.com.
USER’S INFORMATION
Disposal of Old Electrical & Electronic Equipment (Applicable in the European
Union and other European countries with separate collection system
This symbol on the product or on its packaging indicates that this product
shall not be treated as household waste. Instead it shall be handed over to
the applicable collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health,
wich could otherwise be caused by inappropriate waste handling of this
product. The recycling of materials will help to conserve natural resources.
For more detailed information about recycling of this product, please contact
your local city office, your household waste disposal service or the shop
where you purchased the product.
Guaranteed by
Fracarro Radioindustrie SRL
Via Cazzaro n.3 – 31033 Castelfranco Veneto (TV) – ITALIA
– Tel: +39 0423 7361
Fax: +39 0423 736220
Fracarro France S.A.S.
7/14 rue du Fossé Blanc Bâtiment C1 – 92622 Gennevilliers Cedex
– FRANCE Tel: +33 1 47283400
– Fax: +33 1 47283421Fracarro (UK) – Ltd
Unit A, Ibex House, Keller Close, Kiln Farm, Milton Keynes MK11 3LL UK
– Tel: +44(0)1908 571571
– Fax: +44(0)1908 571570
www.fracarro.com –
info@fracarro.com –
supportotecnico@fracarro.com – chat
whatsapp +39 335 7762667
SWA..30TS
19-04-2022