SIPATEC TR.Ex Analog Transducer Instruction Manual
- June 3, 2024
- SIPATEC
Table of Contents
SIPATEC TR.Ex Analog Transducer Instruction
- ATEX / IECEx certified for Gases and Dusts
- Measurement in Zone 0/20
- Direct power supply without zener barrier
- Easy plug-in mounting
- Quick and safe installation
- Junction box Ex e integrated
- No variants only one basic unit
- Enhanced temperature range -40 … +70 °C
- Degree of protection IP66
- Analog outputs switchable between mA and V
- Outputs calibrated and scaled
- Integrated display
- Onsite parameterization
- LED status indication
- Low power input <3 W
- Cable length from the transducer to the sensor up to 100 m
- Highly resistant against corrosion by use of high-tech polymer and stainless steel
Safety Notes
- Install in accordance with manufacturer’s instructions and valid standards and rules.
- Unlocking the device or opening the terminal box is only permitted with the power off.
- When installing the unit, make sure that the housing protection type IP66 is maintained in accordance with EN 60529.
- This equipment can be used according to manufacturers’ instructions in Zone 1, 21 (II 2GD) and 22. (II 3GD).
- The sensor circuit can be introduced into the zone 0 (II 1G). Corresponds to the designation II 2 (1) G.
- The device may only be used in measurement media, against which the process-contacting materials are resistant.
- The unit must be connected to the potential equalization (PA), an internal and external terminal is available.
- The unit must be protected against mechanical impact/pressure and UV light.
Technical Data
Dimension
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>