X-PLOR Dust Cap Cartridge User Guide

X-PLOR Dust Cap Cartridge

INSTALLATION INSTRUCTIONS

STEP 1
Removing Cartridge.

1. Turn off the X-PLO₂R® by pressing the power button for 2 seconds.
2. Remove the X-PLO₂R from the carrying bag, if applicable.
3. Remove the battery from the X-PLO₂R.
4. Place the X-PLOâ‚‚R on its side to access the underside of the POC.
5. Pull the cartridge out of the POC by pulling on the cartridge pull handle.
6. Remove the cartridge completely from the X-PLO₂R and throw away.

STEP 2
Installing Cartridge.

1. Remove the cartridge from the mylar bag. The new cartridge has a dust cap on top. Remove the dust cap. Make sure there is no dust or debris where the dust cap was located.
2. Insert the new cartridge top first into the X-PLO₂R. Do not leave the cartridge ends exposed; the cartridge should be inserted into the X-PLO₂R as soon as the used cartridge is removed.
3. Push the cartridge into the X-PLOR so it is fully inside.
4. The cartridge pull handle should lay flat once the cartridge is secured.
5. Connect charged battery to the X-PLO₂R.
6. Turn on the X-PLO₂R by pressing the power button for 2 seconds. Set the flow setting to your prescribed setting and use it normally.

XplorOxygen.com

References

• Belluscura | Portable Oxygen Concentrator Manufacturer

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>