YI GOND TOYS 11CH Remote Control Excavator Instruction Manual

YI GOND TOYS 11CH Remote Control Excavator

Preface
Thank you for purchasing our product.Please read this manual carefully before use and retain it for future reference.

Product Configuration

Major Parts Of The EXCAVATOR

1. Excavators arm
2. Track-Type Wheels
3. Simulation Control Deck
4. Battery compartment

Battery Installation And Use

Remote Control Battery Installation
Unscrew counter clockwise to open the battery compartment cover.install 2X1 .5″AA” batteries (batteries not included) into the battery compartment accroding to the given polarity, screw clockwise to close the battery compartment.

• Don’t play in dangerous places such as public roads.select a safe place for operating to avoid dangerous.

• Don’t use this product on elevated places such as tables or counters, and avoid falling or heavy falls.

• Don’t place this product in direct sunlight or high temperature places to avoid deformation or even damage caused by sun exposure and high temperature.

• Don’t play on rainy days or water (mud) pits. Prevent being wetted by water, so as not to cause malfunction, if you accidentally get wet, please use a cloth with good
  water absorption to absorb the water.

• Be careful not to touch the wheels with fingers, hair, clothes, etc., to avoid injury.

• When the battery of the r/c car or the remote control is low, the speed of the remote control car will slow down significantly. Please replace the battery or charge it in time.

• Please do not violently move the excavator digging arm by hand to avoid damage to the excavator.

• Don’t break the remote control antenna to prevent injury.

• Maintenance: wipe the surface stains with a dry cloth.

NOTE

The hydraulic rods and crawlers of this product are easy to damage and fall off. If the parts are damaged or lost, you can purchase the same model parts from the manufacturer or dealer, and replace and install them yourself to ensure the complete structure of the product. Do not use parts of different models or different brands for installation to ensure the structural safety of the product.

Important Notices

Note! The products are manufactured by batches after performances have been strictly demonstrated ane practically tested to verify meeting safety standards.For any use of the remote-controlled model.the manufacturer or dealer won’t bear any responsibility for accidents resulted from abnormal parts usage and wearing,impeoper assembling or operation in safe environment. please be sure to operate this product under a safe environment.

Troubleshooting

Product Problem: Excavator cannot start

The Solution:

1. The power switch is off, please turn it on.
2. The battery negative is not poles of installed the battery correctly, to ensure please that check the battery positive is installed correctly.
3. The with a battery new is battery. exhausted, please charge the battery or replace with a new battery.

Product Problem: The remote control cannot be used

The Solution:

1. The with a remote new one. control battery is exhausted, please replace it with a new one.
2. Excavator is not in the control range of the remote control, please keep it in the controllable range.

Battery Precautions

• Toys use battery type: Excavator uses 1 X3. 7V rechargeable battery; remote control uses 2X1 .5V “AA” non-rechargeable batteries (batteries not included);
• Nonrechargeable batteries are not to be charged;
• Rechargeable batteries can only be charged under adult supervision;
• Rechargeable batteries are to be removed from the toys before being charged;
• Take out and put in the battery according to the label on the toy battery room;
• Only batteries of the same or equivalent type as recommended are to be used;
• Don’t mix old and new batteries;
• Don’t mix alkaline.standard (carbon zinc),or rechargeable (nickel cadmium)batteries;
• Exhausted batteries are to be removed from the toy. If it is not used for a long time, please take out the battery in the toy;
• The supply terminals are not to be short-cirui ted;
• This product can only be charged with the delivered USB charging cable, and it is not allowed to use USB charging cable that are not recommended. USB charging cable is not toys;
• The USB charging cable to be used with the product should be regularly examined for potential hazard such as damage to the cable or coed, plug, enclosure of other parts and that in the event of such damage ,the peoduct must not be used until that damage had been properly removed.

Flight Safety Guidelines

• Keep the small accessories away from kids to avoid accidents, not suitable for children under 3 years.

• Don’t play in dangerous places such as public roads.select a safe place for operating to avoid dangerous.

• Don’t use this product on elevated places such as tables or counters, and avoid falling or heavy falls.

• Don’t place this product in direct sunlight or high temperature places to avoid deformation or even damage caused by sun exposure and high temperature.

• Don’t play on rainy days or water (mud) pits. Prevent being wetted by water, so as not to cause malfunction, if you accidentally get wet, please use a cloth with good
  water absorption to absorb the water.

• Be careful not to touch the wheels with fingers, hair, clothes, etc., to avoid injury.

• When the battery of the r/c car or the remote control is low, the speed of the remote control car will slow down significantly. Please replace the battery or charge it in time.

• Please do not violently move the excavator digging arm by hand to avoid damage to the excavator.

• Don’t break the remote control antenna to prevent injury.

• Maintenance: wipe the surface stains with a dry cloth.

Excavator Battery Installation

Making sure that the power swich is in the OFF position, remove the screw form the battery cover and remove the battery compartment cover.Insert the power connector of the 3. 7V rechargeable battery into the power connector of the excavator battery compartment.screw clockwise to close the battery compartment.

Excavator Battery Charging

Insert the power connector of the battery into the USB charging cable, and then connect the USB charging cable to the adapter or the USB port on the computer.When charging is proceeding, the eeps solid on.when charging is finished, the red light is off.The charging time is about 3-re4 d light hours.k

• Please check whether the adapter input voltage is consistent with the current voltage before charging;
• The output voltage of the adapter should be consistent with the battery voltage;
• When charging, it must be done under adult supervision;
• Keep away from flammable materials when charging, and have an adult watch over when charging.

Operation Demonstration

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>