RemoteTech RT-G0812E Electronic Key User Manual
- June 3, 2024
- RemoteTech
Table of Contents
User’s Manual
Electronic Key
FCC ID: 2AOKM- G2ABC
RT-G0812E Electronic Key
IC: 24223-G2ABC
MODEL: RT-G0812E, RT-G0811E, RT-G0800E, RT-G8506E, RT-G0797E
This remote has lock, unlock, power back door, Remote Start, panic buttons;
you can open or close the vehicle with the remote transmitter.
LOCK Button:
When you press the LOCK button, it locks all the doors
UNLOCK Button:
Pressing the button unlocks the driver’s door. Pressing the button again
within 5 seconds unlocks the other doors.
LIFT GATE Button:
Pressing the LIFTGATE button twice on the remote opens and closes the
LIFTGATE.
LIFT Glass Buttons:
Pressing LIFT Glass buttons twice within five seconds on the remote opens and
closes the LIFT Glass.
REMOTE START Button:
Press the remote start button twice within 5 seconds. The vehicle will stay in
the Remote Start mode for a 15-minute cycle. Press and release remote start
button once to exit Remote Start mode.
PANIC Button:
When you press the PANIC button, the vehicle will start sounding the horn and
flushing the hazard lamp. To stop the alarm, press any button on the
electronic key.
TRUNK Button:
Pressing the TRUNK button twice on the remote opens and closes the trunk.
HATCH Button:
Pressing the trunk or hatch button opens and closes the hatch.
FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
IC WARNING:
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device