JIUBEI M6 Wireless Chime Doorbell User Manual
- September 30, 2024
- JIUBEI
Table of Contents
JIUBEI M6 Wireless Chime Doorbell
Features
- 5. Doorbell Button
- 6. Reset Button
- 8. Type-C Port(Battery Charging)
- 9. Security screw hole
Indicator Light
In the Box
Charge the Doorbell
Fully charge the doorbell by a 5V1A USB charger and a Type-C USB cable. It
takes about 10 hours to fully charge.
WARNING : Lots of events
If you have excessive number of visitors, you might need to charge it sooner.
Install your Doorbell
Mark drill holes and use a bit to drill holes in your wall. Insert anchors and secure your doorbell with mounting and security screws.
Step 1:
Step 2:
Set up your Wireless Chime (Optional)
Connect the doorbell to the doorbell chime, and get instant alert in your home when someone rings the doorbell. The chime plugs into any 5V USB port, you can place it anywhere in the home.
NOTICE: The doorbell is only compatible with our wireless chime, and not compatible with traditional doorbell chimes. The wireless chime is optional. If it is not installed, doorbell notifications will still go directly to the Kement.
The Basics
Set up your Wireless Chime
Step 1
Before the setup process, make sure your doorbell is on, then plug the chime
into the USB port and it’s ready to use.
Step 2:
Press the pair button.
Step 3:
Press the Doorbell Button for pairing.
Step 4:
Press the Doorbell Button again to verify the chime and doorbell work
properly.
Volume of chime is not adjustable.
FCC STATEMENT
FCC Warning Statement: Changes or modifications to this unit not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>