Fender TELPR6211 5.8Ghz Guitar Wireless System Instruction Manual
- September 27, 2024
- fender
Table of Contents
TELPR6211 5.8Ghz Guitar Wireless System
“`html
Product Information
Specifications:
-
5.8Ghz bandwidth
-
5725 – 5850MHz
-
Working Range: Up to 70ft actual range; depends on RF signal
absorption, reflection, and interference. -
Audio Frequency Response: Dynamic Range & Signal-To-Noise
110dB -
Battery Life: 8 Hours
-
RF Sensitivity: -90dBm
-
Total Harmonic Distortion: (specification missing)
Product Usage Instructions
Charging:
Charging time: 2.5 hours. Use the USC-C charging port for both
the Transmitter and Receiver.
How to Use:
-
Turn on the Transmitter and Receiver power by holding the Power
button for 3 seconds. -
Connect the Transmitter to your Guitar.
-
Connect the Receiver to the guitar pedal or guitar amp.
How to Pair:
Hold the Power / sync button for 5 seconds. The Status Led will
flash red and blue. After successful pairing, the Status Led will
turn green.
Frequency Tables:
| Frequency Point | Frequency (MHz) |
|---|---|
| 1 | 5730 |
Frequently Asked Questions (FAQ)
Q: What types of instruments can this wireless system be used
with?
A: This system can be used with Acoustic guitar, Electric
guitar, and Electric bass guitar.
Q: What is the battery life of this wireless system?
A: The battery life is approximately 8 hours.
“`
5.8Ghz Guitar Wireless System
BASIC OPERATION
Transmitter
USC-C charging port Power / sync button 1/4″ Input jack Active / Passive mode
switch
Active mode for active guitar pickup Passive mode for Passive guitar pickup
Receiver
USC-C charging port Power / sync button 1/4″ output jack
Transmitter and Receiver logo
1/4″ adapter
USE WITH MULTIPLE INSTRUMENT TYPES
Acoustic guitar, Electric guitar, Electric bass guitar.
Status Led
How to charging
Charging time: 2.5 hours
How to use
1. Turn on the Transmitter and Receiver power, hold on the Power button 3 sec. 2. Transmitter connect to Guitar 3. Receiver connect to the guitar pedal or guitar amp
How to pair
Hold on the Power / sync button 5sec. The Status Led will flash red and blue led. After successful pairing the Status Led will be green.
5.8Ghz Frequency Tables
1 Frequency point 2 Frequency point 3 Frequency point 4 Frequency point 5 Frequency point 6 Frequency point 7 Frequency point 8 Frequency point
5730MHZ 5735MHZ 5743MHZ 5753MHZ 5758MHZ 5764MHZ 5774MHZ 5781MHZ
9 Frequency point 10 Frequency point 11 Frequency point 12 Frequency point 13 Frequency point 14 Frequency point 15 Frequency point 16 Frequency point
5789MHZ 5799MHZ 5804MHZ 5811MHZ 5820MHZ 5830MHZ 5836MHZ 5844MHZ
Specifications
5.8Ghz bandwidth
5725 – 5850MHz
Working Range
Up to70ft actual range; depends on RF signal
absorption, reection and interference.
Audio Frequency Response
20Hz 20KHz(-2dB)
Dynamic Range & Signal-To-Noise 110dB
Ratio
Battery Life
8 Hours
RF Sensitivity
-90dBm
Total Harmonic Distortion
<0.1%, 100mVrms 1Khz
RF Output Power
<25 mW E.I.R.P. max
Latency
Less than 5ms
High Resolution audio
24-bit/48kHz
Charging current and voltage
5V, 0.6A
IC warning statements:
-English Warning Statement: RSS-GEN ISSUE 5, 8.4 User manual notice This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B). -French Warning Statement: RSS – Gen version 5, 8.4 avis du manuel de l’utilisateur Cet appareil contient un émetteur / récepteur sans licence conforme au RSS sans licence d’innovation, science et développement économique Canada.L’opération doit satisfaire aux deux conditions suivantes: Cet équipement peut ne pas causer d’interférence. L’équipement doit accepter toute interférence, y compris toute interférence qui pourrait entraîner un fonctionnement indésirable de l’équipement.
Specific Absorption Rate (SAR) information: This device meets the government’s
requirements for exposure to radio waves. The guide lines are based on
standards that were developed by independent scientific organizations through
periodic and thorough evaluation of scientific studies. The standards include
a substantial safety margin designed to assure the safety of all persons
regardless of age or health. The SAR limit of ISED (Canada) is 1.6 W/kg
averaged over one gram of tissue. Device types: Portable _PMN NAME_WIRELESS
SYSTEM (IC: 8690A-TELPR6211) has also been tested against this SAR limit.
according to this standard is less than 1.6W/kg w. Informations sur le débit
d’absorption spécifique (DAS) : cet appareil est conforme aux exigences
gouvernementales en matière d’exposition aux ondes radio. Les lignes
directrices sont basées sur des normes qui ont été élaborées par des
organisations scientifiques indépendantes grâce à une évaluation périodique et
approfondie d’études scientifiques. Les normes comprennent une marge de
sécurité substantielle conçue pour assurer la sécurité de toutes les
personnes, quel que soit leur âge ou leur état de santé.
La limite SAR d’ISED (Canada) est de 1,6 W/kg en moyenne sur un gramme de
tissu. Types d’appareil : Portable PMN NAME WIRELESS SYSTEM (IC :
8690A-TELPR6211) a également été testé par rapport à cette limite SAR. selon
cette norme est inférieure à 1,6 W/kg w.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>