VIMOQ A60s 128GB Smartphone Installation Guide
- September 27, 2024
- VIMOQ
Table of Contents
A60s 128GB Smartphone
Product Information
Specifications:
- Operating System: Android™ 12 (Go edition)
- Specific Absorption Rate (SAR) information: Available
Product Usage Instructions
SIM/SD Card Installation:
- Power off the mobile device.
- Refer to the provided picture for proper SIM/SD card
installation.
Charging the Phone:
-
You can charge your device using a charger or by connecting it
to the computer using a USB cable (included with the phone). -
Ensure the correct orientation of the charger plug (front and
back). -
Use only the provided itel charger and cables to prevent device
damage. Using other chargers or cables may void the phone
warranty.
Frequently Asked Questions (FAQ)
Q: What should I do if my device does not charge?
A: If your device is not charging, try using a different
charging cable or power source. Ensure that the charging port is
clean and free from debris.
Q: Can I use any charger to charge the device?
A: It is recommended to use only the provided itel charger and
cables to avoid damaging the device and invalidating the
warranty.
SIM/SD card installation
1. Power off mobile. 2. Refer to the following picture for SIM / SD card
installation.
Charging the phone
You can charge your device using a charger or by connecting it to the computer
using a USB cable (comes with the phone).
1. Please remind the front and back of the plug.
2. Use only itel charger and cables. Other chargers or cables may damage the
device. This will invalidate your phone warranty.
FCC Caution
Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Information to user. Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
Information to the user. Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: -Reorient or relocate
the receiving antenna. -Increase the separation between the equipment and
receiver. -Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. -Consult the dealer or an experienced
radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health. FCC
RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg
averaged over one gram of tissue. Device types: A662LM (FCC ID: 2AJMN-A662LM)
has also been tested against this SAR limit. The highest SAR value reported
under this standard during product certification for use at the ear is 1.25
W/kg and whenproperly worn on the body is1.05 W/kg.
Body-worn Operation This device was tested for typical body-worn operations.
To comply with RF exposure requirements, a minimum separation distance of 1.0
cm must be maintained between the user’s body and the handset, including the
antenna. Third-party belt-clips, holsters, and similar accessories used by
this device should not contain any metallic components. Body-worn accessories
that do not meet these requirements may not comply with RF exposure
requirements and should be avoided. Use only the supplied or an approved
antenna.
Operating SystemAndroidTM 12 (Go edition) Android is a trademark of Google
LLC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>