VIMOQ A49 Play Smartphone User Manual
- June 11, 2024
- VIMOQ
Table of Contents
**VIMOQ A49 Play Smartphone
**
Explosion diagram specification
| 1 | A631 TP | 2 | Three in one frame pasted with foam glue |
|---|---|---|---|
| 3 | A631 LCD | 4 | Trim as-earpiece |
| 5 | Shell as-face | 6 | receiver |
| 7 | main board | 8 | motor |
| 9 | 2.5 Screw | 10 | Front camera |
| 11 | Rear camera grounding conductive cl | 12 | Earpiece grounding conductive |
| 13 | Main rear camera | 14 | Front camera grounding conductive cloth |
| 15 | receiver FPC | 16 | Upper pan assembly |
| 17 | Upper pan assembly Main board grounding conductive spong | 18 | Fingerprint |
grounding conductive sponge
19| fingerprint| 20| Side key FPC
21| Coaxial cable| 22| Rear auxiliary camera
23| Rear auxiliary camera| 24| Rear auxiliary camera
sealing silicone sleeve
25| Rear main camera lens| 26| Auxiliary lens rear camera
27| 3.0 Screw| 28| Battery cover assembly
29| Battery compartment steel sheet| 30| Lower pan assembly
31| SPK| 32| Auxiliary plate
33| SPK FPC| 34| Display screen / TP pad insulation adhes
35| Display screen conductive sponge| |
Know your phone
- Front camera
- Volume key
- Power key
SIM/SD car installation
- Power off mobile.
- Refer to the following picture for SIM/ SD card installation.
Charging the phone
You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone).
- Please remind the front and back of the plug.
- Use only VIMOQ charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.
FCC Caution
Labelling requirements.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Information to user.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health. FCC
RF Exposure Information and Statement The SAR limit of USA(FCC) is 1.6 W/kg
averaged over one gram of tissue. Devicetypes:A631LO (FCC ID: 2A5RQ-A631LO)
has also been tested against this SAR limit. The highest SAR value reported
under this standard during product certification for use at the ear is 0.402
W/kg and when properly worn on the body is 0.509 W/kg. This device was tested
for typical body-worn operations with the back of the handset kept10mm from
the body. To maintain compliance with FCC RF exposure requirements, use
accessories that maintain a 10 mm separation distance between the user’s body
and the back of the handset. The use of belt clips, holsters and similar
accessories should not contain metallic components in its assembly. The use of
accessories that does not satisfy these requirements may not comply with FCC
RF exposure requirements, and should be avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimumseparationdistanceof1.0 cm must be maintained
between the user’s body and the hand set, including the antenna. Third-party
belt-clips, holsters, and similar accessories used by this device should not
contain any metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be
avoided. Use only the supplied or an approved antenna.
Operating System: Android
TM Android is a trademark of Google LLC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>