SPYPOINT SPLB-10 Lithium Battery Solar Panel User Guide
- September 26, 2024
- SPYPOINT
Table of Contents
SPYPOINT SPLB-10 Lithium Battery Solar Panel
IN THE BOX
- 1x Lithium battery solar panel
- 1x 1.5 mm output cable for SPYPOINT cameras
- 1x Installation Mount
- 1x Installation strap
- 1x Quick start guide
WARNING: The USB charger block is not included.
SPECIFICATIONS
- Max power: 5 W
- Charging time: ≈ 6-12 hours with USB cable
- Operating temperature: -20°C to 60°C (-4°F to 140°F)
- Capacity: 7.5 Ah, 27.75 Wh
- USB (20 W): USB-C
- Input voltage: 5 V/2 A
- Output voltage: 12 V/1.5 A
- Physical dimensions: 19 cm (W) X 20 cm (H) X 4.5 cm(D) 7.48″ (W) X 7.87″ (H) X 1.77″ (D)
CHARGING THE LITHIUM BATTERY SOLAR PANEL
Initial Charge with USB Cable
Plug in one of the included USB-C cables to the USB-C input/output port. You
will select the cable needed based on your charging block type (USB-A or
USB-C). During this charging process the red lights flash to indicate charge
level. The green light is steady on when charging. Consult charge indicator
below.
WARNING: DO NOT CONNECT other devices while charging the solar panel with the USB cable.
Charging with solar
Place the unit in direct sunlight with no shade. The red charge indicator LEDs
do not display when charging by solar. Only the green LED will flash. Press
the TEST button to see charge indicator LEDs. Consult charge indicator key
below.
CHARGE INDICATOR LED KEY
How to check the power status
Pressing the TEST button will display the charge level. Full charge will be
indicated with all of the LEDs showing Red.
WARNING: Always install a fully-charged solar panel.
INSTALLATION
Find a location where the panel will receive as much direct sunlight as possible and use the supplied adjustable mounting arm to mount the panel. Typically, the panel should be facing South. Be sure to use the 12 V output port on the back of the panel and the supplied 1.5 mm output cable.
- Using anything other than the 12 V port and output cable could damage your device and void the warranty.
Insert the yellow-tipped end into the power pack and the black end into your camera. When in normal use the red LEDs do not light up unless you push the TEST button.Do not leave AA batteries in your camera while using the external solar panel.
Note: The other output ports and cables included with the solar panel allow it to be used with other cameras, phones, and devices.
TIPS
- The panel requires 4 to 6 hours of direct sunlight per day for best performance.
- The solar panel will get the maximum amount of natural light if it faces South and angled at 45 degrees.
- Keep your solar panel clean of pollen, dirt, and debris for best performance.
- Route the cables along the mounting bracket and as close to the camera as possible to avoid chewing or tearing from animals. Excess cable length should be tucked behind the panel or camera.
- Ensure both ends of the cables are installed completely and securely. Turn the camera ON, trigger a photo, and check your app to ensure proper network connection before leaving the area.
CAUTION
- Do not drop, disassemble, or puncture the power pack.
- Do not place in fire, extremely high temperature, or water.
- If you notice something not right when in use or when charging, like melting, a bulge in the housing or the unit getting extremely hot stop using it immediately.
WARNING: Failure to follow these safety instructions may result in fire, electric shock, damage, or other injury. This power pack is not a toy. Keep away from children and operate outside.
DISPOSAL
Only use original spare parts and accessories.
If, one day, your solar panel has been used so intensively that it has to be
replaced, or if you no longer have any use for it, you are obliged to dispose
of it at a recycling center. Information on return points for your electrical
appliance can be obtained from your local waste disposal company or from your
local administrative offices. Electrical appliances not only contain valuable
recyclable raw materials but also substances which, if disposed of improperly,
can affect public health and the environment. Help ensure that valuable raw
materials are recycled by returning your old appliance to a central collection
point. The WEEE (Waste Electrical and Electronic Equipment Directive) symbol
represents the obligation.
FCC
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
- This device must not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
WARRANTY
1-year limited warranty, visit spypoint.com/warranty for complete details.
Need assistance? Just contact us!
SPYPOINT SPLB-10
Distribution Center 3000 Gannett Avenue, Des Moines IA 50321 • USA SPYPOINT
330 de la Jacques-Cartier, Victoriaville QC G6T 1Y3 • Canada THOMAS JACKS
LIMITED Apex House, Timothy’s Bridge Rd, Stratford-upon-Avon CV37 9BF • United
Kingdom EUROHUNT GmbH Harzblick 25,99768 Harztor OT Ilfeld • Germany.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>