OneOdio T44 Open Ear Bluetooth Earphones User Manual

OneOdio T44 Open Ear Bluetooth Earphones

T44
Open-Ear Bluetooth Earphones
User Manual

Contenuto della confezione

Technical Specifications

• Product Model: T44
• Color: Black Speaker Sensitivity 119±3dB
• Impedance: ‘ 1612±159/0
• Frequency Response : 20Hz—20kHz
• Microphone Sensitivity : -38±1 d3V/Pa
• Bluetooth Version: V5.3
• Bluetooth Range: 10m/33ft
• Battery Capacity: Earphones 70mAh x 2; Charging Case 600rnAh
• Playback Time: 40 hours
• Charging Time : 2 hours
• Charging Interface :USB Type-C
• Input Voltage: DC
• Speaker Diameter: 17x12mm
• Single Earphone Weight: 9.3g
• Charging Case Weight : 60.2g
• Total Weight : 78.8g

Button Functions

LED Indicator Lights

• Pairing Mode: Main earphone flashes red and blue alternately, while the secondary earphone flashes blue slowly.
• Once connected. the lights of both earphones turn off.
• Charging Status: The earphones’ red light stays on for 10 seconds and then shuts off: the battery status indicator remains on until fully charged, at which point it also turns off.

Bluetooth Pairing

• Keep the Bluetooth earphones and the mobile phone (or other connected devices) are within 1 meter (3 ft.) of each other; the doser the distance, the easier the pairing.
• When no external devices are connected, opening the case powers on the earphones. Once the left and right earphones successfully establish a connection With each other, the main earphone’s LED will flash alternately in red and blue, signaling that the earphones are now in pairing mode and ready to connect to a

Bluetooth device.

1. Keep the Bluetooth earphones and the mobile phone (or other connected devices) are within 1 meter (3 ft.) of each other; the farther the distance, the easier the pairing.
2. When no external devices are connected, opening the case powers on the earphones. Once the left and right earphones successfully establish a connection With each other, the main earphone’s LED will flash alternately in red and blue, signaling that the earphones are now in pairing mode and ready to connect to a Bluetooth device.
3. Enable Bluetooth on your mobile phone (or other Bluetooth device), and begin scanning for devices. Your mobile phone will list all detectable Bluetooth devices. Select the earphones labeled ‘T44’. A successful connection is confirmed when lights on both earphones turn off.
4. Bluetooth Auto-Reconnect:
   • After initial pairing. the earphones automatically reconnect to the last connected device on subsequent uses.
   • If the connection is Est but the device returns within the effective range within 5 minutes, the earphones will automatically reconnect.

Multi-Point Connection

1. Initial Connection: Automatically power on the earphones by opening the lid, which enters it into pairing mode to connect with the first mobile phone.
2. Switch Connection. To connect a second mobile phone, first disable Bluetooth on the currently connected mobile phone. This allow the earphones to re-enter pairing
3. Reconnect First Phone: After connecting the second mobile phone, reactivate Bluetooth on the first mobile phone and manually reconnect it to the earphones.

Charging the Earphones

1. Connect the charger to the charging case’s port.
2. While charging, the earphones’ red light wil stay lit for 10 seconds before turning off and the charging case light will remain on for 3 seconds before shutting off.
3. Use only chargers approved by OneOdio. Unauthorized or non-company chargers may damage the earphones or, in extreme conditions, cause explosions. or may the product warranties.
4. Repeated charging and discharging of the earphones WiM lead to a decrease in battery performance over time, which is a normal occurrence for au rechargeable batteries.

Safety Precautions

1. This product is not a toy. Children should use the earphones only under adult supervision.
2. Do not place the device in environments that are too hot or tCX) con (below OOC/320F or above 450C/1130F).
3. Keep the device’s indicator light away from the eyes of children or animals.
4. TO prevent hearing damage, avoid using the earphones for long periods at high] volumes for extended periods Of time.
5. For your safety. please be mindful Of traffic conditions when using the earphones while driving or walking.
6. To avoid interference with a pacemaker, do not wear or place the earphones within 10 cm (4 in.) of the device.
7. Do not use Bluetooth devices during thunderstorms, as they can cause the device to malfunction and increase the risk of electric shock.

FCC WARNING

This device complies With part 15 of the FCC Fales. Operation is subject to the following two conditions.

1. This deviæ may not cause harmful interference, and
2. This device must accept

Any received, including interference that may cause operation. Any or modifications not expressly approved by the party responsible for compliance could void the users au authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 16 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inte#rence in a residential hstdlation. This equipment uses and can radiate radio frequency energy and. if ru)t installed and used in accordance with the instructions, may cause harmful interference to radio communications. However: there is no guarantee that interference will not occur in a particular instance. If this does cause harmful interference to radio or televise reception, which be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

• Reorient or the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into a CWtlet on a Circuit different that to which the receiver iS connected.
• Consul! the dealer or an experienced radio/TV technician heb The device has been evaluated to meet general RF exposure standards.

The device can use jn pot-tabb exposure (X”d1tiOfi with out retrication.

LIMITED WARRANTY

Our friendly customer service team is ready and waiting to help. Here is how we can connect:

Customer Service
Global: http://www.supereq.net
info@supereq.net
Global•.+85269403848 (Mon to Fri 9:00 am-6:30 pm, UTC +8 HKT)
Manufacturer: Yenona Audio Co. Limited
ADD.. Building 41-1, No. 3 Nanshan Road, Songshan Lake Park, Songshan
Lake Management Committee Dongguan City, Guangdong Province. China

FCC 10: 2AR6F-T44
Made in China
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions.

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>