OneOdio F2 Wireless Earbuds User Manual

OneOdio F2 Wireless Earbuds

First-time setup

Take out the earbuds and charging compartment from the package, put the earbuds in the charging compartment, close the lid and wait for 3 seconds.

Take out the L or R earbuds, the earbuds are automatically turned on, and the earbuds enter the TWS pairing mode.

Search for the pairing name “ F2 ”and select it.

Product operation instructions

Turn on

• In the turn-off state, press and hold the multi-function button for 2 seconds.
  Open the cover of the charging case, and the earbuds will automatically turn on.

Turn off

• In the power-on state, press and hold the function button for 6 seconds to power off.
• When the earbuds are put in the charging case, the cover of the charging box is closed, and the earbuds are automatically turned on.

Touch area

Standby

| Anc on Transparency mode Anc off|

Press hold 3 seconds

---|---|---
Call reject| Press hold 2 seconds
Play/pause Receive call|

Single tap

Game mode on Game mode off|

Triple tap left

Playing

| Next song| Double tap right
Previous song| Double tap left
Call reject| Press hold 2 seconds
In Call| Call stop| Double tap

In Siri

| Call siri| Triple tap right
Cancel siri| Press hold 2 seconds

Charging for case

Plug the charging cable into the charger port to charge the charging box and earbuds. When charging, the indicator light of the charging box flashes and the green light is always on when it is full.

Charging for earbuds

The charging box closes the lid, the indicator light flashes, the charging box charges the earbuds, the earbuds automatically Disconnect.

Battery level

Judge the battery usage by the battery indicator.

Any attempt to remove or replace the battery will damage the product and void the product warranty.

Specification

• Product model: F2
• Bluetooth version: V5.2
• Audio decoding: SBC, AAC
• Frequency response range: 20Hz~20kHz
• Effective distance: 15m
• Input: DC 5V1A
• Standby time: about 80H
• Music playtime/talk time: ≥6 hours
• Use time for noise reduction: 5.5H
• Working hours: about 6H (earphone) 24H (charging box) Size: 57.7441.724.97mm

Fitting

Try all ear tips for the best fit and proper seal. Place in the ear canal and slightly rotate to adjust for best fit.

Wrong-way to wear

Safety instructions for use

To avoid hearing damage, keep the volume at a moderate level. Avoid listening to music at high volume for long periods of time, which may cause permanent damage to hearing or loss of hearing. Please do not use F2 for driving, cycling, crossing roads, etc., where your concentration is required.
Note: Audio and video may be slightly out of sync when watching video using headphones.

After charging, please pull the charging cable out of the body to avoid the product being charged for a long time. The output voltage and current of the charger is 5V/1A or 5V/1.5A is preferred.If the output voltage and current of the charger exceed the specified, it will cause serious damage to the product, and the product warranty will be invalid at the same time.

FCC Warning

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.  Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Radiation Exposure Statement
• This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
• This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>