OneOdio A70 Bluetooth Over Ear Wireless Headphone User Manual
- June 6, 2024
- OneOdio
Table of Contents
WARNINGS/CAUTIONS
www.oneodio.com
info@oneodio.com
OneOdio
A70
|
---|---
|
|
|
|
IMPORTANT SAFETY INSTRUCTIONS
Please read and keep all safety and use instructions.
WARNINGS/CAUTIONS
-
Do NOT use the headphones at a high volume for an extended period.
-
To avoid hearing damage, use your headphones at a comfortable, moderate volume level.
-
Turn the volume down on your device before placing the headphones in/on your ears, then turn the volume up gradually until you reach a comfortable listening
-
Do NOT use your headphones while driving for phone calls or any other purpose.
-
Do NOT use the headphones at any time the inability to hear surrounding sounds may present a danger to yourself or others, e.g., while riding a bicycle or walking in or near traffic, a construction site or railroad, etc.
-
Remove the headphones, to ensure you can hear surrounding sounds, including alarms and warning signals.
-
Be aware of how sounds that you rely on as reminders or warnings may vary in character when using the headphones.
Do NOT use the headphones if they emit any loud unusual noise. If this happens, turn the
-
headphones off and contact OneOdio customer
-
Remove headphones immediately if you experience a warming sensation or loss of audio.
-
Do NOT use mobile phone adapters to connect headphones to airplane seat jacks, as this could result in injury or property damage due to
-
Do NOT use the headphones as aviation communication headsets except in case of
No incoming audio will be heard with a discharged or improperly installed battery. This could result in the potential of missed communications while piloting an aircraft.
Extremely loud ambient noise levels common to many propeller-driven aircraft may impair your ability to receive incoming audio communications, particularly during takeoff and climb out.
The headphones are not engineered for noise conditions, altitude, temperature or other environmental conditions common in non-commercial aircraft, resulting in possible interference to critical communications.
Contains small parts which may be a choking hazard. Not suitable for children under age 3.
This product contains magnetic material. Consult your physician on whether this might affect your implantable medical device.
- To reduce the risk of fire or electrical shock, do NOT expose this product to rain, liquids or
- Do NOT make unauthorized alterations to this
- Use this product only with an agency-approved power supply that meets local regulatory requirements (e.g., UL, CSA, VDE, CCC).
- Do not expose products containing batteries to excessive heat (e.g. from storage in direct sunlight, fire, or the like).
REGULATORY INFORMATION
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by YI ZHAO (SHENZHEN) CO., LIMITED. could void the user’s authority to operate this equipment.
This device complies with part 15 of the FCC Rules and with Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation. This device complies with FCC and Industry Canada
radiation exposure limits set forth for the general population. It must not be
co-located or operating in conjunction with any other antenna
or transmitter.
Meets IMDA Requirements.
CAN ICES-3 (B)/NMB-3(B)
Management Regulation for Low-power Radio-frequency Devices
Article XII
According to “Management Regulation for Low-power Radio-frequency Devices”
without permission granted by the NCC, any company, enterprise, or user is not
allowed to change frequency, enhance transmitting power or alter original
characteristic as well as performance to approved low power radio-frequency
devices.
Article XIV
The low power radio-frequency devices shall not influence aircraft security
and interfere with legal communications; If found, the user shall cease
operating immediately until no interference is achieved. The said legal
communications mean radio communications operated in compliance with the
Telecommunications Act.
The low-power radio-frequency devices must be susceptible to interference from
legal communications or ISM radio wave radiated devices.
DON’T attempt to remove the rechargeable lithium-ion battery from this
product. Contact your local Oneodio retailer or other qualified professional
for removal.
YI ZHAO (SHENZHEN) CO., LIMITED. hereby declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU and all other applicable EU directive requirements. The complete declaration of conformity can be found at: www.oneodlo.com
For Europe:
The frequency band of operation 2400 to 2483.5 MHz:
Bluetooth: Maximum transmit power less than 20dBm EIRP.
Please dispose of used batteries properly, following local regulations. Do not incinerate.
REGULATORY INFORMATION
This symbol means the product must not be discarded as household waste and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling help protect natural resources, human health, and the environment. For more information on the disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.
Removal of the rechargeable lithium-ion battery in this product should be conducted only by a qualified professional.
Please contact your local OneOdio retailer or see https://www.oneodio.com for further information.
Names and Contents of Toxic or Hazardous Substances or Elements
|
Toxic or Hazardous Substances and Elements
Part Name| Lead (Pb)| Mercury (Hg)| Cadmium (Cd)| Hexavalent (CR(VI))|
Polybrominated Biphenyl (PBB)| Polybrominated diphenyl ether (PBDE)
PCBs| X| 0| 0| 0| 0| 0
Metal Parts| X| 0| 0| 0| 0| 0
Plastic Parts| 0| 0| 0| 0| 0| 0
Speaker| X| 0| 0| 0| 0|
Cables| X| 0| 0| 0| ()|
This table is prepared in accordance with the provisions of SJ/T 11364.|
0: Indicates that this toxic or hazardous substance contained in all of the
homogeneous materials for this part is below the limit requirement of GB/T
26572.
X: Indicates that this toxic or hazardous substance contained in at least one of the homogeneous materials used for this part is above the limit requirement of GB/T 26572.
Charging temperature range: 0° C – 45° C
Discharging temperature range: -20° C – 60° C
C&E Connection E-Commerce (DE) GmbH
Add.: Zum Linnegraben 20, 65933, Frankfurt am
Main, Germany
Tel. +4906927246648
E-Mail: info@ce-connection.de
APEX CE SPECIALISTS LIMITED
Add.: 89 Princess Street, Manchester, M1 4HT, UK
Tel. +441616371080
E-Mail: info@apex-ce.com
Manufacturer: VI ZHAO (SHENZHEN) CO., LIMITED
Add.: 6th Floor, T3 Creative Building, Shenzhen Colorful Huawei Cultural And
Creative Expo City,
No. 5010 Baoan Avenue, Caowei Community, Hangcheng Street, Baoan District,
Shenzhen.
UK Declaration of Conformity
Hereby, YI ZHAO (SHENZHEN) CO., LIMITED declares that the product type Y80B is
in compliance with the following Directives: Radio Equipment Regulations 2017,
Electrical Equipment (Safety) Regulations 2016, and The Restriction of the Use
of Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012. The full text of the UK declaration of conformity is
available at the following internet address:www.oneodio.com
info@oneodio.com
- Use care with the earphone may be possible excessive sound pressure from earphones and headphones can cause hearing loss.
- Caution: risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
- The device complies with RF specifications when the device is used at 0mm from your body.
Manufacturer’s Name: YI ZHAO (SHENZHEN) CO.,
LIMITED
Product: Wireless headphone
Model number: A70
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>