Solid Apollo Volt.Watts 24V 1 60W Universal Power Supply Instruction Manual

INSTALLATION INSTRUCTIONS

BEFORE YOU BEGIN

• Read and follow all instructions
• Installation must comply with the NEC
• Installation work and electrical wiring should be done by a qualified person(s) in accordance with all applicable codes and standards.
• Ensure the unit has input, output voltage and output wattage proper for your application.

Precautions Before Installing

Check the label and ensure the transformer has the proper input voltage and wattage for the job. Check the wire markings to ensure they match the wiring diagram on this installation guide.

Mounting

The LED driver must be mounted in at least 5″ of a free flow air space for proper ventilation.
The LED driver must never be mounted next to or above heat radiated objects.
The Maximum ambient temperature should not exceed 50 deg.0 (122 deg.F)
If you are installing multiple drivers, keep a minimum space of 5″ Inch between each driver.
SUITALE FOR DRY, DAMP AND WET LOCATIONS.

Input Connections / Grounding

Remove the wiring compartment knockouts and install strain reliefs. With power turned off, route the input wires through a strain relief and connect one wire to black and one wire to white. For all wire connections use only UL listed wire nuts and connectors of suitable size and type. The transformer case MUST be grounded in accordance with the N.E.C. Connect the ground wire to the transformer green wire.

Dimming

Please visit Page 2-3 for a full dimmer compatibility list. Dimmer switch is to be installed on the input (120VAC side) of the driver.

Output Connections

Bring the wires of the light fixture through the other open knockout and connect them to the transformer’s lead wires, V+ to Red, V- to Black.
Make sure all your connections are tight.

Wiring Diagram

A. MLV TRIAC (Leading Edge) Dimmer Wiring Diagram

The Minimum load 20-100%

1. Input 120VAC 60Hz
2. Input wire (Black)
3. Input wire (White)
4. Dimmer (Optional)
5. Green Wire (Ground)

B. Electronic Low Voltage (ELV) Dimmer Wiring Diagram

The Minimum load 20-100%

1. Input 120VAC 60Hz
2. Input wire (Black)
3. Input wire (White)
4. Dimmer (Optional)
5. Green Wire (Ground)

DIMMER COMPATIBILITY

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>