ESSAGER ES-WC11 Magnetic Wireless Charger User Manual
- September 19, 2024
- ESSAGER
Table of Contents
ESSAGER ES-WC11 Magnetic Wireless Charger
PRODUCT DESCRIPTION
Thank you for your choice and trust. This is an ultra-thin magnetic wireless charger,Specially designed for iPhone 12-15 series, ultra-thin magnetic wireless fast charging can provide more accurate charging Positioning to make charging efficiency faster. Supports multiple options of 5W/7.5W/10W/15WMode charging, intelligent fast charging without damaging the device. Magnetic wireless charging, compact, lightweight and easy to use Carrying.
PRODUCT PARAMETER
- Product Name: Magnetic Wireless Charger
- Input: 9V/2.22A
- Output: 5W/7.5W/10W/15W
- Charging induction: < 8mm
- Compatibility: Supports wireless charging devices that comply with Qi standards; Magnetic suction only supports iPhone 12-15 series
PACKING LIST
- Wireless charger *1
- Manual *1
INSTRUCTIONS FOR USE
- The wireless charger comes with a 1m cable, connect the adapter to the power supply.
- Put on a mobile phone that supports magnetic suction, and the wireless charger will automatically aim at the mobile phone and directly magnetically charge it
PRECAUTIONS
- It is recommended to use a high-power adapter above 20W for better experience.
- This product has input over-current and over-voltage protectionfunction, if improper use will shut down or reduce the output power, please check whether the equipment is abnormal or improper use.
- Keep the operating environment temperature at 0-25°C. Do not place the product in water, fire, high (>40°C) and low temperature (<-20°C) environments, and keep out of children’s reach.
- Please use a dry soft cloth to clean the surface, do not use chemicals, soap or detergent to clean.
- Improper use or improper placement of this product by the user may result in loss of life or damage to this product, which is not covered by the warranty, please understand.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- This device must accept
CAUTION: any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. such modifications could void the user’s authority to operate the equipment.
- The device has been evaluated to meet general RF exposure requirement.
- To maintain compliance with FCC’s RF exposure guidelines, the distance must be at least 20 cm between the radiator and your body, and fully supported by the operating and installation configurations of the transmitter and its antenna(s).
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>