APKPure JZ-24001 RGB LED IR Controller Instructions
- September 19, 2024
- APKPure
Table of Contents
REMOTE CONTROL INSTRUCTIONS
JZ-24001 RGB LED IR Controller
1.Turn On/Standby
Press this key to tunn on unit or switch to standby mode. At power on, unit
will automaticly turn on and restore to previous status .
2/9. Dynamic Mode Adjust
Switch to dynamic mode from static color, or switch between dynamic modes.
3/10. DynamicSpeed Adjust
Adjust dynamic playing speed.Press SPEED+to increase speed and press SPEED- to
decrease. Unit will switch to dynamic mode If press this key at static color
mode.
4/5. Static Color Adjust
Switch to static color mode from dynamic mode, or switch between static
colors. 6.Direct Color Select
Shortcut key to static colors. When press the specific color key, LED will
play the same static color. The direct colors are included
in’ColOR+’and’COLOR’ operation.
7/8.Brightness Adjust
Adjust static color brightness. Press BRIGHT + to increase brightness and
press BRIGHT- to decrease. Unit will switch to static color mode If press this
key at dynamic mode
11.DemoMode
Press this key will switch to Demo mode. At demo mode, it plays 17 dynamic
modes in loop, each mode repeat 3 times. This device complies with part 15 of
the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turing the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>