DeLaval Energizer ESE25BS Solar Fence Device Instruction Manual

September 17, 2024
Delaval

DeLaval Energizer ESE25BS Solar Fence Device

Specifications

  • Product: DeLaval Energizer ESE25BS
  • Operating Instruction: ESE25BS
  • Safety Hints: SECURA ANIMAL

Product Information

The DeLaval Energizer ESE25BS is an electric fencing equipment designed for use in livestock management. It features an integrated energy-saving function that adjusts energy usage based on the fence’s condition, ensuring efficient operation. The energizer delivers pulses into the fence to provide containment for animals. Proper grounding is essential for optimal performance, requiring installation in a moist and overgrown area.

Usage Instructions

Operation and Control

  1. Turn on the energizer with button (1).
  2. After a few seconds, a green LED will flash with the pulses under the window indicating proper operation.
  3. If there is no flashing LED, check the battery status or inspect for faults in the energizer.

Battery Indicator
The battery indicator light provides information on the battery status

  • Flashing light: 40-100% residual capacity – Good battery
  • Flashing light continous light: 20-40% residual capacity – Charge the battery
  • Green red/green red: 0-20% residual capacity – Low battery

Energy Saving Function
The energy-saving function automatically adjusts energy usage based on the fence’s insulation level. Higher usage occurs with poorly insulated fences while lower usage is seen with well-insulated fences.

Grounding
Ensure proper grounding in a moist and overgrown area for faultless operation and optimal output.

Service
Repairs should only be performed by qualified service personnel using manufacturer-recommended replacement parts. Technical alterations may occur.

FAQ

  • Q: What should I do if the battery indicator shows a low battery?

    • A: If the battery indicator displays a low battery, it is recommended to charge the battery to ensure continuous operation of the energizer.
  • Q: How do I know if there is a fault in the energizer?

    • A: If the green LED does not flash when the energizer is turned on, it may indicate a fault either in the battery or in the energizer itself. Check for these issues to troubleshoot.

DeLaval Energizer ESE25BS

OPERATING INSTRUCTIONS

Operating instruction ESE25BS

in connection with safety hints SECURA ANIMAL

Energizer has to be turned OFF before any intervention!

Operation and control (Fig. 4)

Turn on with button (1). After few seconds a green LED is flashing with the pulses under the window (1). The energizer give pulses into the fence. If there is no flashing either the battery is flat or there is a fault in the energizer.

Storage, recharge, mounting and connections
If not used the unit has to be stored in light: e.g. in a south window especially during winter time. This is the only way to safeguard the built-in accumulator against low level discharge. As the case may be, please check the battery voltage monthly and recharge it with the battery charging unit.

Before and after use always recharge the energizer first in the sun – in minimum 1 day – as the case may be, please charge the battery only with the included battery charging unit, so that the battery will stay in good working order (see Fig. 3). During charging do not use the energiser and do not connect it to the fence (see Fig. 3 and Fig. 4). Please use only recharge-able 12V-lead-batteries. Rechargeable batteries with aeration should just been charged in well ventilated rooms. Control the accumulator indication only at daybreak (without sunlight)! Drive the ground rod into moist ground. Connect the earth lead to the earth terminal and the fence connecting lead to the fence terminal. The panel must be oriented to the south.

Buttons: Turn on with button on/off 1 – after few seconds a green LED control flashing with the pulses. If there is no flashing either the accu is flat or there is a fault in the controller.

Accumulator indication (Fig. 2)
Control only at daybreak! The battery need to be charged at the latest, when it is discharged of 80% (only 20% charging capacity), so that a deep discharge can be prevented.

The battery indicator light „accu-test“ is

Please note, that this values can vary due to the dependence of temperature (capacity) and measuring deviation (tension).

WORKING PRINCIPLE
The solar panel produces electric current when being exposed to daylight, where sunlight produces much more current than the light of rainy day. The fence controller requires a constant current, day and night. Thus the panel current is stored in an integrated accumulator which delivers the controller current. The solar panel is not always capable to fully ensure the battery charge -especially in the winter month (ca. October-February)

Help: Recharge the battery externally in time!

ENERGY SAVING FUNCTION
This electric fencing equipment with integrated energy saving function adapts the energy usage automatically to the condition of the fence. This means less energy usage regarding well insulated fences and higher energy usage regarding badly insulated fences (conduction due to vegetation etc.)

GROUNDING
For a faultless operation and to obtain best possible output a good grounding is very important. Therefore the grounding must be made at a rather moisty and overgrown place.
Minimum an 1m earth stake ( e.g. 12mm ø ) and / or additional 1 – 2 longer earth stakes shall be used. With long fences and on dry soil a ground return wire with intermediate groundings (every 50 m) is necessary. The distance between the system earth and the protective system earth of the supply net work shall be at least 10 m.

SERVICE
Repair is only to be made by qualified service personnel. Only by the manufacturer commanded replacement parts must be used.
SUBJECT TO TECHNICAL ALTERATIONS !

Technical data

CEE
max. fence line length

SUBJECT TO TECHNICAL ALTERATIONS !

Installation and connection

WARNING: Do not connect to mains-operated equipment including battery chargers!

EU Declaration of Conformity

Name of product: DeLaval energizer E, ESE
Type/model: E60M, E120M, E250M, E2B, ESE4B, ESE7BS, ESE50B, ESE7BM, E8BM, ESE16BM, ESE20BM, ESE25BM, ESE120BM, ESE25BS
Report No. D0000124996

The product complies with requirements of the following directives

  • Electromagnetic compatibility directive EMCD 2014/30/EU
  • Restriction of the use of certain hazardous substances (RoHS) – 2011/65/EU

Harmonized standards which have been used or parts there of

  • EN 55014-1:2006/A2:2011
  • EN 55014-2:2015

Other technical standards and specifications used

  • EN 60335-2-76:2005/A2:2015
  • Fulfills RoHS by design and purchase control

This declaration of conformity is issued under the sole responsibility of the manufacturer.

Tumba 2021-12-14 Signed:

  • Name: Magnus Berg
  • Position: Executive Vice President
  • Department: Product Management & Development

Person authorised to compile the technical file:

  • Product Manager

  • P.O. Box 39

  • SE 147 21 TUMBA

  • Sweden

  • DeLaval International AB

  • P.O. Box 39

  • SE 147 21 TUMBA

  • Sweden

85399B- 06/2022
(DeLaval – ESE25BS)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals