Vista Professional Outdoor Lighting 1051YM Linear LED Floodlight Instruction Manual
- September 14, 2024
- VISTA PROFESSIONAL OUTDOOR LIGHTING
Table of Contents
Vista Professional Outdoor Lighting 1051YM Linear LED Floodlight
Product Information
Specifications:
- Model: 1054YM
- Series: Commercial Series Linear Floodlight
- Manufacturer: Vista Professional Outdoor Lighting
Product Usage Instructions
- Ensure the electrical supply is turned off at the circuit breaker before starting installation or servicing of the luminaire.
- Thread the Luminaire Supply Conductor cable through the Cord Seal and the Yoke Mount Bushing into the Junction Box Ld. Tighten the Yoke Mount Bushing securely.
- Route the luminaire supply conductors into a wet location rated J-Box. Attach conduit supply conductors to the luminaire conductors, ensuring correct polarity: line to black, neutral to white, and ground to green. Connect using approved wiring methods.
- Secure the Junction Box Lid onto the Junction Box using the provided screws. Tighten securely.
- Adjust the aim of the fixture and re-tighten the Yoke Aiming Hex Nut(s) underneath the Yoke Decorative Caps.
- Re-assemble the Decorative Caps onto the Yoke.
- Tighten the Yoke Locking Set Screws to secure the aiming.
- Supply power to the luminaire and check for proper operation.
FAQ:
Q: Can I modify the design of the fixture?
A: Vista Professional Outdoor Lighting reserves the right to modify the
design and/or construction of fixtures without further notification.
IMPORTANT NOTE:
- Luminaire must be installed and grounded in accordance with the National Electrical Code (NEC) and local codes.
- Luminaire is UL listed for above grade installation only.
- Always use UL recognized wire connectors for connections.
MAINTENANCE: To assure proper operation and efficiency, lens must be kept clean and free of dirt, dust,leaves, trash and mineral deposits from water. A regular scheduled maintenance program is recommended.
SAFETY WARNING: Luminaire can become hot. Take care when locating luminaires.
NOTE: Save these instructions for future reference.
LUMINAIRE MOUNTING (YOKE) TO JUNCTION BOX(ES)
- Make sure electrical supply is off at circuit breaker before starting luminaire installation or servicing luminaire.
- Thread Luminaire Supply Conductor cable through the Cord Seal, the Yoke Mount Bushing through Yoke center hole and into Junction Box Ld. Tighten the Yoke Mount Bushing fully.
- Route luminaire supply conductors into wet location rated J-Box (by others). Attach conduit supply conductors (by others) to the luminaire conductors observing polarity, line to black, neutral to white, and ground to green. Connect the supply / luminaire conductors using approved wiring methods.
- Secure the Junction Box Lid onto the Junction Box using the Junction Box Lid Screws. Tighten.
- Adjust the aim of the fixture and firmly re-tighten the Yoke Aiming Hex Nut(s) underneath the Yoke Decorative Caps.
- Re-assemble the Decorative Caps onto the Yoke.
- Tighten the Yoke Locking Set Screws to secure the aiming.
- Supply power to the luminaire and check for proper operation.
www.VistaPro.com · email@vistapro.com · Fax: (888) 670-VISTA (8478)
1625 Surveyor Avenue · Simi Valley, CA 93063 · 805-527-0987 · (800) 766-VISTA (8478
Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of fixtures shown in this document without further notification.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>