Leuchtturm Albenverlag 20-40X Zoom Microscope Installation Guide
- September 15, 2024
- Leuchtturm Albenverlag
Table of Contents
20-40X ZOOM MICROSCOPE
20-40X Zoom Microscope
1. Eyepiece
2. Zoom Wheel
3. LED On/Off Button
4. Focusing Lever
5. Battery Insulate| 6. Specimen Stage
7. Battery Door
8. Battery Door Screw
9. Specimen Slides Covers
10. Specimen Slide
---|---
HOW TO USE
Getting Ready
Remove the Battery Insulate (5) by pulling it outward.
Observing with Specimen Stage (6)
- Place the object of observation onto the Specimen Slide (10) and place a Specimen Slide Cover (9) on top of the object. Insert the Specimen Slide into the Specimen Stage.
- Place the Microscope into the Specimen Stage and press the LED On/Off Button (3) and observe through the Eyepiece ( 1) .
- Turn the Zoom Wheel to adjust the desired degree of magnification (from 20X to 40X) .
- Slide the Focusing Lever (4) gradually until the image is clear and sharp.
Observing without Specimen Stage
- Place the microscope directly on top of the object of observation and press the LED On/Off Button and observe through the Eyepiece.
- Turn the Zoom W heel to adjust the desired degree of magnification {from 20X to 40X) .
- Slide the Focusing Lever (4) gradually until the image is clear and sharp.
BATTERY INSTALLATION
If the LED light becomes dim, it means that it’s time to replace the batteries.
- Unscrew the Battery Door Screw (8) with a screwdriver and remove the Battery Door (7) in the direction shown by the arrow.
- Remove the used-up batteries and insert 3 pcs of fresh LR44 button cells into the battery compartment in the right polarity.
- Close the Battery Door and tighten the Battery Door Screw with a screwdriver.
2037090012R
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>